27
8. Maintenance
Changing Batteries
The battery statuses of the sensors are checked every hour. If the low battery indicators
light up, replace the batteries for the corresponding unit immediately.
Changing Batteries for the Main Console Unit
1.Toavoidlosingdataandrecords,connecttheAC/DCadaptortothemainunitrst.
2. Remove the latch at the back and replace all batteries. Do not mix old and new batteries.
3. Replace the cover.
Changing Batteries for the Remote Sensors
1. Replace the batteries following the setup instructions for the corresponding sensor.
2. When the batteries are properly installed, the sensor will resume sending signals to the
main console unit.
To enforce a search immediately for all remote signals, press and hold DOWN on the
main console unit.
Cleaning
The main console unit and outer casings for the remote sensors can be cleaned with a
damp cloth. Small parts can be cleaned with a cotton tip or pipe-cleaner.
Never use any abrasive cleaning agents and solvents. Do not immerse any units with elec-
tronic parts in water or under running water.
Anemometer
- Check that the wind vane and wind cups can spin freely and are free from dirt, debris or
spider webs.
Rain Sensor
Like all rain gauges, the rain sensor is prone to blockages due to its funnel shape. Check-
ing and cleaning the rain sensor from time to time will maintain the accuracy of rain mea-
surements.
- Detach the protective screen and lid. Remove any dirt, leaves or debris by cleaning the
items with soapy water and a damp cloth. Clean small holes and parts with a cotton tips
or pipe-cleaner.
- Look out for spiders or insects that might have crawled into the funnel.
- Also clean the swinging mechanism with a damp cloth.
