TXG237
94
PRE-DELIVERY
・
Check that engine oil level is correct.
・
Check that coolant level is correct.
・
Check fan belt tension, 10mm deflection, when sub-
jected to a force of thumb pressure.
・
Check that transmission oil level is correct.
・
Install a sufficient amount of No. 2 diesel fuel to
complete pre-delivery service.
・
Ensure clean and tight cable connections at battery.
Battery must be securely mounted.
・
Check air cleaner, element, hoses and clamps for
correct installation.
・
Check brake and clutch pedal linkage for correct
freetravel.
・
Check steering, brake and clutch linkage cotter pins
and lock nuts for secure installation.
・
Check filter element and, all connections and
clamps for hydraulic pump and filter.
・
Check oil level in front drive axle. Place fuel filter
shutoff valve in the “ON” position. Take up position
in operator’s seat and engage parking brake.
・
Place all shift levers in neutral and then depress
clutch pedal.
・
Place rear PTO and mid PTO selector levers in
neutral.
NOTE: Engine will not start unless range shift lever
is selected to neutral, rear PTO, and mid
PTO selector levers are in neutral.
・
Set throttle lever at half to full throttle and turn main
switch counterclockwise 5-10s.
・
Turn main switch clockwise to “ON.” Oil pressure
and alternator warning lights will illuminate. Hold in
“on” position 1-2s.
・
Turn main switch to “Start” to crank the engine.
Release key to “ON” position the moment engine
starts. Check that warning lights go out.
・
Allow engine to warm up to operating temperature
at about 1500rpm.
・
Operate Tractor to confirm it operates smoothly at all
speeds including four-wheel drive (if it is equipped).
・
Operate PTO to see that it functions properly.
・
Check that all lights and instruments operate properly.
・
Check brakes for balanced operation.
・
Check warm engine low idle speed, 1250-1300 rpm.
・
Check warm engine high idle speed, 2760-2860 rpm.
・
Set throttle lever at idle, shut off engine and check
Tractor for coolant, lubricating oil or fuel leaks.
・
Check that safety start system functions correctly.
・
Lubricate all fittings.
・
Check tire inflation pressures.
・
Check front wheel toe-in.
・
Test anti-freeze to see that it is adequate for local
climate conditions.
NOTE: Factory fill is set to -34°C.
・
Check to see that all safety decals and safety
switches are in place.
・
Clean and polish sheet metal as necessary.
・
Fill fuel tank to prevent moisture accumulation.
・
Review this Operator’s Manual with the customer
when delivering or demonstrating Tractor.
