Bedienungsanleitung Jablotron CL-302 (Seite 2 von 2) (Englisch)

555009

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

Central locking with remote control CL-302SL 2/2 MDC51106

The fifth door

It is also possible to control a fifth door lock by

using an extra actuator. Use model CM-2 (two

wires) and connect it in parallel to one of the

front door actuators. This way the locking

system can only be operated manually from the

front doors.

Note: study the function of the fifth door lock

carefully before you decide to install an

actuator. Some systems do not allow it.

Testing

Check the wiring and then install the fuse onthe

red cable (15A) and connect the battery. Check

the function of the locking system by using the

key in the front door locks. Then test the

function of the remote controls.

Adding of a new remote control

There are two remote controls in each CL-

302SL set. The receiver unit can be operated

by a maximum of three remote controls. To add

an additional remote control or to replace an

original one (in the case one is lost) perform the

following procedure.

Entering of Learn Mode: First, switch off

ignition key and disconnect the power to the

CL-302SL by removing the fuse. Then open the

control unit housing. Press and hold the button

marked "Learn Code" inside the unit and

reconnect the power while still holding down the

button. The blinkers will flash four times and

you can now release the button. Now the

receiver unit is in learning mode, ready to learn

new codes.

Remote control codes learning: You should

activate all the remote controls (one by one)

which you want to use to operate the system.

The receiver unit will store each remote control

code in its memory (confirmed by a blinker

flash). Keep in mind that only three controls can

be taught. If you try to teach a fourth control, the

first one will be forgotten and so on. If you

activate only one control in learning mode, you

will be able to control the car only with this one

control.

To exit the learning mode, disconnect the CL-

302SL power for two minutes.

Note: All the codes are stored in non volatile

memory, so the receiver unit will remember

them even if the power is disconnected.

Operation:

Each short pressing of the remote control

button will lock or unlock the car (according to

the initial position of the locks). Locking of the

car is indicated by one flash of the blinkers.

Unlocking is indicated by two flashes. Doors

can not be locked with the remote control while

the ignition key is ON.

Re-lock function: If the car is not entered

(neither door switch nor ignition key input is

triggered) within one minute after unlocking, the

CL-302SL will automatically generate a lock

instruction. (Connecting the white wire to the

GND instead of to the door switches will disable

this function)

Confirmation of Control Code Validity: If

the receiver unit receives an invalid signal from

the remote control (for example: if there was an

attempt to scan the code by a car thief, or, while

rare, as may happen after the remote control

battery has been disconnected for a long time)

then the receiver will not respond to the signal

from the remote control. In this case, the

system will ask for a confirmation of the control

code. To provide confirmation, open the car

with key an turn ignition key on. Press any

button on the remote control. Now the remote

control should work as usual.

Maintenance: The system does not need any

special maintenance. Check if the locks can be

operated easily by hand every three months.

Lubricate the locks before and after each winter

season. If a lock freezes in winter, or is

mechanically blocked for any reason, remove

the control unit fuse to avoid damage to the

actuator.

If the distance from your car at which the

locking system can be operated decreases,

then replace the remote control battery. Normal

life time of a good quality battery should be

about one year. A suitable replacement battery

is BAT-12.

Internet: www.jablotron.cz

Tel.: +420 483 559 999

fax: +420 483 559 993

Pod Skalkou 33

466 01 Jablonec nad Nisou

Czech Republic

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Jablotron CL-302 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info