Bedienungsanleitung Jablotron RC-86 (Seite 1 von 1) (Englisch)

554857

Zoom out

Zoom in

Vorherige Seite

1/1

Nächste Seite

RC-86 wireless keyfob

The RC-86 is a component of Jablotron’s OASiS 8x series alarm systems. It is designed to

remotely control setting/unsetting, trigger panic alarms, and control other appliances. The big

advantage is the possibility of configuring it to 433 MHz (JA-60 systems, UC-216, UC-222

receivers etc). The keyfob indicates its flat battery. A two button version of the case is also

available. Contact your dealer.

Enrolling to an Oasis control panel

A pair (left or right side) of the keyfob buttons can be enrolled to a control panel by pressing and

holding both buttons. See the OASiS control panel installation manual for more details.

If you wish to remove the keyfob from the system, erase it from its address in the control panel.

The natural reaction of the pair of buttons is setting and unsetting for each button respectively,

and panic alarm triggering by pressing both buttons together. If a reaction other than natural is

assigned, the reaction will only be triggered by buttons

or (according to which pair was

enrolled).

If you enroll both pairs of buttons to two different addresses in the control panel, then different

reactions and sections can be assigned to each pair of buttons. Then, for example, one pair could

set/unset the complete system, and the other pair could be used for partial setting.

Remaining buttons can be used to control another device such as e.g. a Jablotron car alarm, or

UC-8x and AC-8x receivers, UC-216, UC-222 …

Locking the keyfob

If four buttons version of the keyfob is used, keys can be locked or unlocked by pressing a

diagonal button pair (

+ or + ). When the keys are locked, the keyfob LED flashes rapidly

if any button is pressed (no signals are sent under these conditions). See the Keyfob configuration

chapter.

Panic alarms

Panic alarms can be triggered when buttons +

are pressed simultaneously. The keyfob

can be set so that a panic alarm is triggered when any one button on the keyfob’s left side (even

or )

is pressed. See the Keyfob configuration chapter.

Using with other products

In addition to Oasis control panels, the keyfob can also be used with other Jablotron products that

communicate via Oasis protocol. Examples are relay receivers type UC-8x and AC-8x. Guidance

on using the keyfobs can be found in the manual of the desired receiver.

If you want to use the keyfob for 433 MHz a pair of keys can be switched to this mode. See the

configuration chapter.

Keyfob configuration

1. Press and hold

The keyfob flashes

once and after a while starts to light

continuously.

2. Keep

pressed while pressing

times according to the table below.

3. Then release

to end configuration

mode.

4. As confirmation, the LED flashes the

same number of times as you pressed

the

button.

The default mode is 5: No lock - unlock

possible, no one-button PANIC possible,

both pairs are 868MHz

Battery replacement

Indication of a flat battery is provided by

the keyfob LED. After any button is pressed

the LED flashes long (as usual) and then

briefly flashes twice as an indication of a flat

battery. The keyfob works as usual, it’s just that the working range of the keyfob could be reduced.

This indication is also done on the control panel (on its keypad or communicator). The indication is

cancelled when a new battery is inserted (L1016 type).

Expired batteries should not be thrown into the garbage, but disposed of according to local regulations.

Technical parameters

Voltage: alkaline battery type L1016 (6.0 V)

(Power Supply type C acc.to EN 50131-6)

Typical battery lifetime approx. 3 years (5 daily activations)

Communication band: 868 MHz/433MHz

Communication range approx. 30 metres (open area)

Op. environment acc. to EN 50131-1 II. indoor general

Operational temperature range -10 to +40 °C

Security grade acc.to EN 50131-1 2

Can be operated according to ERC REC 70-03

Complies with ETSI EN 300220,EN 55022, EN 50134-2, EN50130-4, EN60950-1

JABLOTRON ALARMS hereby declares that the RC-86 is in compliance with the essential requirements

and other relevant provisions of Directive 1999/5/EC.. The original of the conformity assessment can be

found at www.jablotron.com, Technical Support section.

Note: Although this product does not contain any harmful materials we suggest you return the product to the

dealer or directly to the producer after use.

MGE53602

function

mode

pressed

keyfob

lock

PANIC

433MHz

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Jablotron RC-86 Anleitung

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info