Bedienungsanleitung JBL Arena 170 (Seite 4 von 112) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch, Norwegisch, Finnisch)

809567

Zoom out

Zoom in

Vorherige Seite

1/112

Nächste Seite

www.jbl.com

ENGLISH

ARENA 180/170/130/120 – LEFT AND RIGHT CHANNELS

For best results, place the speakers 6 – 10 feet (1.8m – 3m) apart. Angling the speakers toward the listening position can improve

the stereo imaging. The speakers will produce the most accurate stereo soundstage when the angle between the listener and

the speakers is between 40 and 60 degrees.

Use the included carpet spikes for stability if you are placing your Arena 180/170 speakers on a thick rug or plush carpeting. The

carpet spikes can be manually screwed into each rubber foot on the base of the speaker.

CAUTION: Floorstanding (tower) loudspeakers have a high center of gravity and may become unstable

and tip over during earthquakes or if they are rocked, tipped or improperly positioned. Consider anchor-

ing these speakers to the wall behind them, using the procedures and hardware customary for anchor-

ing bookcases and wall units. You are responsible for proper installation and proper selection of hard-

ware.

PLACEMENT

•

Position Arena 130/120 shelf speakers so that their tweeters

are approximately at ear level. Peel oﬀ the adhesive backing

and apply 4 rubber feet to the corners on the bottom of

each speaker.

Rubber

Feet

40° – 60°

6 – 10 ft

(1.8m – 3m)

>20 in

(>51cm)

WALL-MOUNTING THE ARENA 120

We have designed the Arena 120 speakers to mount directly

onto a wall. Each speaker has two keyholes on the back and

will require two 1-1/2” (38mm), #10 wood screws fastened

to a wall stud. If a wall stud is unavailable, install an anchor

appropriate for a 1-1/2”, #10 screw.

NOTE: You are responsible for the correct selection and use

of mounting hardware (available through hardware stores)

that will ensure the proper and safe wall-mounting of the

speakers.

Keyholes

Rubber cushions

1) Using the included wall template, mark the positions on

the wall where you would like to place the mounting

screws.

2) Fasten two 1-1/2” (38mm), #10 wood screws to the wall

using the markings from Step 1 as your guide. Leave an

1/16” (1.59mm) space between the wall and screwhead.

If a wall stud is not available, use an appropriate anchor.

3) To protect wall, attach 4 rubber cushions (included) in

suggested locations.

4) Place the speaker on the wall by aligning the keyholes

on the back of the speaker to the screwheads on the

wall.

Once positioned properly, the speaker should slide

down slightly and become secure.

For best performance, we recommend that you place the

speakers at least 20 inches (51cm) away from the side walls.

Generally, bass output will increase as the speaker is moved

closer to a wall or corner.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

JBL Arena 170 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info