650519
32
Zoom out
Zoom in
Vorherige Seite
1/201
Nächste Seite
28
Hose installation leaks and draws in air Check all connections are airtight and t correctly.
Airstone too close to suction pipe
If air is additionally provided by a membrane
pump, check that there is sucient distance
between the airstone and the suction pipe.
“IN” and “OUT hoses mixed up Reconnect hoses correctly
High ow resistance due to dirty lter material or
lter material in net bag
Clean lter material and do not ll long-term lter
material (JBL MicroMec, JBL SintoMec) in nely
meshed net bags. For special problem solutions,
only use the original CristalPro lter material
with the appropriate foam edge.
Stopcock on pump head stiff
Cause Solution
Washers do not glide
Dismantle hose connection block (7) and spray
the stopcocks with commercially available silicone
oil. Reassemble hose connection block and move
stopcock backwards and forwards a few times.
Fish dead and/or water cloudy
Cause Solution
Nitrite poisoning due to too rapid change from
old” to “new”. Cleansing bacteria thrown away
with old lter.
Run an old and new lter parallel for 2 weeks in
the same aquarium or incorporate 1/3 of the old
lter material in the new lter. Never carry out a
general clean up” of the aquarium at the same
time!
Filter material for problem cases (available at your specialist retailer)
12
Filter material with foam edge
The following filter material kits are constructed according to a new two-stage principle which
is specially designed for the CristalProfi Filter “e” range. They are comprised of a core section
and an edge section. The core is made up of a relatively fine special filter media requiring a
finely meshed net bag. The edge consists of coarse foam. With this design, the water flows
slowly through the special filter media providing optimum efficiency, whilst at the same time
the overall water flow through the filter is obstructed as little as possible thanks to the coarse
foam edge. The size and volume of each kit is measured specifically for the filter basket of the
JBL CristalProfi e range.
JBL CarboMec Pad
Kit with high-capacity active carbon
Removes residue medication, water discolouration and high molecular pollution from fresh
water and salt water. Virtually no increase in conductivity and phosphate levels in the water.
32

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für JBL CristalProfi e1901 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info