Bedienungsanleitung Jensen JHD910BT (Seite 13 von 16) (Englisch)

509198

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

JHD910BT

WEATHER BAND OPERATION

Accessing the Weather Band

Press the WB button (7) to directly access the weather band mode from any other function mode.

What is the NOAA Weather Radio?

NOAA is a nationwide system that broadcasts local weather emergency information 24 hours a

day. The U.S. network has more than 530 stations covering the 50 states, as well as the adjacent

coastal waters, Puerto Rico, the U.S. Virgin Islands and the U.S. Pacific Territories. Each local

area has its own transmitting station and there are a total of seven broadcasting frequencies

used: 162.400MHz (CH1), 162.425MHz (CH2), 162.450MHz (CH3), 162.475MHz (CH4),

162.500MHz (CH5), 162.525MHz (CH6) and 162.550MHz (CH7).

How many stations can I expect to receive?

Since the broadcasts pertain to local weather and information, the transmission power is usually

very low (much less than AM or FM stations) which means you will usually receive only one

station unless you are on the edge of two or more broadcast signals. The most you will receive is

two or three, and that is rare.

Is it possible I won't receive any stations?

Depending on location, it’s possible to receive a very weak signal or none at all. Also, similar to

AM and FM signals, weather band signals are subject to surrounding conditions, weather,

obstructions of the signal by hills or mountains, etc. If no NOAA signals are found/received, the

“NO SIG” icon will flash in the display and the tuner will scan all seven NOAA frequencies every

30 seconds.

How will I know I am tuned to the weather band?

When you select the weather band, the “WB” icon will appear on the display panel, along with the

current channel indication. Press TUN+ (11) or TUN- (9) to tune to each of the seven channels

until you find the weather band station broadcasting in your area.

NOAA Weather Alert

The Weather Alert function adds an additional level of user safety by automatically switching from

the current function mode to weather band mode for a minimum of 60 seconds if a NOAA warning

tone (1050 Hz) is received/detected. If no additional warning tone is received for 60 seconds, the

unit will switch back to the last known function mode.

The Weather Alert function can be turned “on” or “off” by the Audio/Menu key, as described on

page three. When “ON” (default), the Weather Alert icon appears in the display and the weather

tuner remains active, even when the radio is turned off (as long as the power is still applied to the

radio). If a weather alert is issued, the radio will turn on and play the announcement for 60

seconds, then turn back off and revert to weather alert monitor mode.

If the Weather Alert function is set to “OFF”, no Weather Alert icon appears in the display. The

radio will not respond to any weather alerts when it is off and will not automatically switch to the

weather band if an alert is issued.

NOTE: If the unit is programmed for European operation, the WB function will be disabled.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Jensen JHD910BT Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info