Bedienungsanleitung Jensen MP1516 (Seite 6 von 120) (Englisch)

509234

Zoom out

Zoom in

Vorherige Seite

1/120

Nächste Seite

• If this unit is installed in a vehicle that does not have an ACC (accessory) position

on the ignition switch, the red lead of the unit should be connected to a

terminal coupled with ignition switch ON/O operations. If this is not done, the

vehicle battery may be drained when you are away from the vehicle for several

hours.

• Secure the wiring with cable clamps or adhesive tape. To protect the wiring,

wrap adhesive tape around them where they lie against metal parts. To avoid

short-circuiting, cover all disconnected lead with insulating tape. There is a

possibility of short-circuiting if the leads are not insulated.

• Route and secure all wiring so it cannot touch any moving parts, such as the

gear lever and handbrake. Do not route wiring in places that get hot, such as

near the heater outlet. If the insulation of the wiring melts or gets torn, there is a

danger of the wiring short-circuiting to the vehicle’s body.

• Don’t pass the yellow lead through a hole into the engine compartment to

connect to the battery. This will damage the lead’s insulation and cause a very

dangerous short.

• Do not short any leads. If you do, the protection circuit may fail to work when it

should.

• Never feed power to other equipment by cutting the insulation of the power

supply lead of the unit and tapping into the lead. The current capacity of the

lead will be exceeded, causing overheating.

• Since an unique audio I/C circuit is employed, never wire the unit so the

speaker leads are directly grounded or the left (-) and right (-) speaker leads are

common.

• When this product’s source is switched ON, a control signal is outputted

through the blue lead. Connect to an external power amp’s system remote

control or the car’s Auto-antenna relay control terminal (max. 300mA 12 V DC). If

the car features a glass antenna, connect to the antenna booster power supply

terminal.

• When an external power amp is being used with this system, do not connect

the blue lead to the amp’s power terminal. Likewise, do not connect the blue

lead to the power terminal of the auto-antenna. Such connection could cause

excessive current drain and a major malfunction. Refer to the relevant owner’s

manual for details on connecting the power amp and other units, then make

the connections correctly.

• Do not block any vents or heater panels. Blocking them will cause heat to build

up and may result in re.

• Make sure that the unit has a good chassis ground. A good ground connection

will eliminate most electrical noise. A good chassis ground requires a tight

connection to the vehicles metal chassis. The area around the ground

connection should be clean, bare metal without rust, paint, plastic or dirt for a

good electrical connection.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Jensen MP1516 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info