If a fault occurs, first check the points listed below before taking the set for repair. Do not open the casing
as there is a risk of electric shock. If you are unable to remedy the problem by following these hints, call
service and support at the phone number shown below. Under no circumstances should you try to repair
the set yourself, as this will invalidate the warranty.
Problem Cause Solution
No sound/power. Volume not adjusted. Adjust the volume.
Power cord not securely connected. Connect the AC cord properly.
Batteries used/incorrectly inserted. Insert new batteries correctly.
Display does not function
properly/No reaction to
operation of any of the controls.
Electrostatic discharge. Switch off and unplug the set.
Reconnect after a few seconds.
Poor cassette sound quality. Dust and dirt on the head. Clean deck parts.
Recording does not work. Cassette tab(s) may be broken.
Cassette incorrectly inserted.
Apply a piece of adhesive tape
over the missing tab space
The CD skips tracks. CD damaged or dirty. Replace or clean CD.
Program is active. Quit program mode.
CD playback does not work. CD badly scratched or dirty. Replace or clean CD.
Laser lens steamed up. Wait until lens has adjusted to
room temperature.
ENGLISH
TROUBLESHOOTING
