700489
9
Zoom out
Zoom in
Vorherige Seite
1/24
Nächste Seite
9
AMPLIFIER INPUTS
The MHD750/1 has a single input section
consisting of a pair of RCA-type input jacks on
the Connection Panel of the amplifier and a
pair of input controls on the Control Panel of
the amplifier: an “Input Voltage” switch and an
Input Sens.” rotary control.
Remote
Level
Control
Inputs
L
R
L
R
+12 VDC Ground Remote
Preouts
+12 VDC Ground Remote
The MHD750/1 features stereo inputs, even
though it is a mono amplifier. This has been
done to permit the amplifier to sum stereo
input signals to mono, which is particularly
useful for driving subwoofers. Even if you
have a dedicated mono subwoofer signal
available or are feeding a left channel only or
a right channel only into the amplifier, you
must feed both inputs of the MHD750/1.
Connection of only one RCA input will result
in reduced power output, increased distortion
and can cause the amplifier to overheat. To
connect a mono signal to both inputs, use
an RCA “Y-Adaptor” (sold separately).
INPUT CONTROLS
On the amplifiers control panel you will find
an “Input Voltage range switch and a rotary
control labeled “Input Sens.” (Input Sensitivity).
These controls are designed to match the input
sensitivity of the MHD750/1 to the specific signal
source that is feeding it and must be adjusted,
with care, following the procedures outlined in
this manual. Failure to make correct adjustments
can result in weak output, excessive distortion
and/or undesirable noise in the audio output of
the amplifier!
“Input Voltage” Switch
A wide range of signal input voltages can be
accommodated by the MHD750/1s differential-
balanced inputs (200mV – 8V RMS). This wide
range is split up into two sub-ranges, accessible via
the Input Voltage switch. The Low position
on the Input Voltage switch selects an input
sensitivity range between 200mV and 2V. This
means that the Input Sens. rotary control will
operate within that voltage window. If you are
using an aftermarket source unit, with preamp-
level outputs, this is most likely the position that
you will use (regardless of what voltage output
capability is claimed by the source unit).
The High position on the Input Voltage
switch selects an input sensitivity range between
800mV and 8V. This is for use with speaker-level
outputs from source units and small amplifiers
found in many OEM (factory-installed) systems.
To use speaker-level sources, splice the speaker
output wires of the source unit or small amplifier
onto a pair of RCA plugs for each input pair
or use the JL Audio ECS Speaker Wire to RCA
adaptor (XB-CLRAIC2-SW).
9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für JL Audio MHD750 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info