Bedienungsanleitung Joovy New Room 703X (Seite 5 von 16) (Englisch, Französisch, Spanisch)

780407

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

EN FR ES

• Locate the Velcro® straps near the corners of the mattress.

• Slideonecornerstrapthroughtheslotintheoorofthebassinetandsecuretotheundersideofthebassinet.See Figure 6.3. Repeat this

step on the other three corners.

• Attach the Velcro® strips located at each top corner of the bassinet to the playard. See Figure 6.4.

FOLLOWING INSTRUCTIONS ARE FOR THE CHANGING TABLE

!WARNING

Please read these instructions carefully before use and keep them for future reference.

• Failure to follow these warnings and the instructions could result in serious injury or death.

• FALLHAZARD:Topreventdeathorseriousinjury,alwayskeepchildwithinarm’sreach.

• Never leave child unattended.

• The changing table is designed for use ONLY with this Joovy playard. DO NOT use on any other products or

surfaces.

• The weight limit for the changing table is 25 lbs. (11 kg). DO NOT use changing table as storage.

• DO NOT use changing table as a sleeping or play area.

• DO NOT use changing table if it is damaged or broken.

• STRANGULATION HAZARD: Child can lift the changing table and get neck caught between changing table and

playard frame. ALWAYS remove changing table when child is in the playard.

• Beforeeachuse,makesurethechangingtableisproperlysecuredbypushingdownrmlyinthecenterofthe

changing table.

7 Installing and Using the Changing Table

• Ensure the playard is erected properly. The changing table can be used with or without the bassinet attached.

• Locate the changing table, the short changing table tubes, and the changing table attachment clamps.

• Note where the short changing table tubes and changing table attachment corners are labeled “A” and “B.”

• With the tubes properly positioned (“A” connects to “A” and “B” connects to “B”), feed the plastic piping edges of the changing table

through the slits in the short tubes until both sides are attached. See Figure 7.1.

• Connect both short tubes to the four corners by connecting “A” to “A” and “B” to “B.” See Figure 7.2.

• Once all tubes are connected, connect the snaps of the changing table to all four attachment corners. See Figure 7.3.

• Slidetheattachmentclampstoeachcorneruntiltheyclickrmlyintoplace.See Figure 7.4.

• Rotate the changing table over onto the top rails. Firmly snap the changing table attachment clamps onto the long rails of the playard.

See Figure 7.5. Check to ensure all four attachments are secured on the rails. If the bassinet is installed, the changing table attachment

clamps should not interfere with the bassinet attachments.

TIP: Push down on the attachments towards the center of the rail before doing the outer attachments for an easier installation.

• Attach the extra side clamps to the nearest short side of the playard. See Figure 7.6.

• Carefullylaythechildonthechangingtableandusethebuckletosecuretherestraintstraparoundthechild’swaist.Thestrapcanbe

adjustedtotthechildproperly.

• When not in use, the changing table can hang off the the side of the playard without getting in the way of the bassinet. See Figure 7.7.

• To unattach the parts of the changing table for folding, push in the metal pin at one end of a short tube and pull the tube away from the

corner. See Figure 7.8. Repeat for all sides.

Maintenance

Allofthettings,locks,rivets,andotherhardwareandplasticpartsontheplayardshouldbeinspectedperiodicallytoinsurethattheyare

secured properly and not damaged or malfunctioning. The straps and fabric items and their stitching should also be inspected periodically to

ensure that they are secured properly and not loose, torn or otherwise damaged. All moving parts, such as wheels, and hinges should also

be checked periodically to ensure they are operating properly.

If using this item at the beach you must clean sand off of ALL the parts before packing it into the travel bag. Getting sand in the top rail

locking mechanisms may damage these mechanisms.

Any missing, broken, or worn components should be replaced immediately, and the playard should not be used until they are replaced. Only

originalmanufacturer’scomponentsshouldbeused.Ifneeded,pleasecontactJoovy(USA)orISSIInc.(Canada)atourtoll-freephone

number.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Joovy New Room 703X Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info