Bedienungsanleitung Jotul F 364 (Seite 19 von 100) (Englisch, Holländisch, Französisch, Italienisch, Spanisch)

467783

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

6.0 Maintenance

6.1 Cleaning the glass

The product is equipped with an air wash for the glass. Air is

sucked in through the air vent on the top of the product and

down along the inside of the glass.

However, some soot will always stick to the glass, but the quantity

will depend on the local draught conditions and adjustment of

the air vent. Most of the soot layer will normally be burned off

when the air vent is opened all the way and a fire is burning

briskly in the fireplace.

Good advice! For normal cleaning, moisten a paper towel with

warm water and add some ash from the burn chamber. Rub it over

the glass and then clean the glass with clean water. Dry well. If it

is necessary to clean the glass more thoroughly we recommend

using a glass cleaner (follow the instructions on the bottle).

6.2 Cleaning and soot removal

Soot deposits may build up on the internal surfaces of the

fireplace during use. Soot is a good insulator and will therefore

reduce the fireplace’s heat output. If soot deposits accumulate

when using the product, they can be easily removed by using a

soot remover.

In order to prevent a water and tar layer from forming in the

fireplace you should regularly allow the fire to burn hot in order

to remove the layer. An annual internal cleaning is necessary to

get the best heating effect from the product. It is a good idea

to do this in connection with the sweeping of the chimney and

flue pipes.

6.3 Sweeping of flue pipes to the chimney

On certain free-standing fireplaces the top plate can be lifted off

and the pipe swept through the top.

Otherwise, flue pipes must be swept through the flue pipe

sweeping hatch or through the product’s door opening. Then,

the baffle must be removed.

6.4 Inspection of the fireplace

Jøtul recommends that you personally inspect your fireplace

carefully after sweeping/cleaning. Check all visible surfaces for

cracks. Also check that all joints are sealed and that the gaskets

are in the correct position. Any gaskets showing signs of wear or

deformation must be replaced.

Thoroughly clean the gasket grooves, apply ceramic glue

(available from your local Jøtul dealer), and press the gasket well

into place. The joint will dry quickly.

6.5 Exterior maintenance

Painted products may change colour after several years usage.

The surface should be cleaned and brushed free of any loose

particles before new paint is applied.

7.0 Service

Warning! Any unauthorised change to the product is illegal.

Only use original spare parts.

7.1 Replacing the baffle/exhaust

deflector

(N.B. If you use tools, be aware that the vermiculite plates may

be damaged by rough treatment).

1. Lift up the front edge of the baffle plate and tilt it out

(fig. 29 G). Remove the side burn plates (fig. 29 F) and the

rear burn plate (fig. 29 E).

2. The exhaust deflector, in cast-iron - that is located above the

baffle plate, rests with the bar on the ribs at the rear flue

outlet (fig. 26 A). Lift the exhaust deflector slightly up, pull it

forward and tilt it out.

3. For reassembly follow the same procedure for installation,

but in reverse.

7.2 Replacement of burn plates/base

plate

(N.B. If you use tools, be aware that the vermiculite plates may

be damaged by rough treatment).

1. Lift up the front edge of the baffle plate and tilt it out. Remove

the side burn plates (fig. 29 F) and the rear burn plate (fig. 29 E).

2. Then lift up the grate and the base plate and take it out (fig.

29 D).

3. Follow the same procedure for installation, but in the opposite

sequence.

4. When reassembling the grate and the base plate, make sure

that the riddling bar (fig. 27 A) that moves the riddling grate

is threaded into the slot on the right edge of the grate.

ENGLISH

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Jotul F 364 Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info