10
1.0 Relationship to the
authorities
Installation of a fireplace must be according to local codes and
regulations in each country.
All local regulations, including thosethat refer to national and
European standards, shall be complied with when installing the
product.
Instructions for mounting, installation and use are enclosed with
the product. Prior to using the product the installation must be
inspected by a qualified person.
A product data label in heat resistant material is located on the
heat shield at the back of the product. This contains information
about identification and documentation for the product.
2.0 Technical data
Material: Cast iron
Finish: Paint/enamel
Fuel: Wood
Log length, max.: 50 cm
Flue outlet: Top/rear
Flue dimension:
inside: Ø 175mm/ 240 cm
2
cross section
outside: Ø 200 mm/ 314 cm
2
cross section
Inlet - combustion air: Ø 80 mm
Approx. weight: 186 kg
Optional equipment: Ash solution with riddling grate, side-
and front trim panels, convection
chamber
Dimensions, distances etc. See fig.1
Technical data according to EN 13229
Nominal heat output: 10,0 kW
Smoke gas mass flow: 8,9 g/s
Recommended chimney draught: 14 Pa
Effiency: 81%@10,3 kW
CO emission (13% O
2
): 0,09%
Flue gas temperature: 278
0
C
Operating mode: Intermittent
Table of contents
1.0 Relationship to the authorities ......................10
2.0 Technical data ..................................................10
3.0 Safety precautions ..........................................11
4.0 Installation ......................................................11
5.0 Operating Instructions ...................................13
6.0 Maintenance ...................................................15
7.0 Service .............................................................16
8.0 Operational problems - troubleshooting ......16
9.0 Optional equipment .......................................16
Figures ............................................................................48
ENGLISH
