16
ENGLISH
7.0 Service
Warning! Any unauthorised change to the product is illegal.
Only use original spare parts!
7.1 Changing the burn plates/inner
bottom plate (fig. 4)
1. Remove the side burn plates (fig. 4C) by lifting them up a
little and out.
2. Remove the rear burn plate (fig. 4D).
3. Remove the inner bottom plate (fig. 4E).
4. Follow the same procedure for installation, but in the
opposite sequence.
7.2 Changing the baffle plate (fig. 3)
1. Lift the baffle plate (fig. 3A) up a little and remove it
through the door.
2. For re-installation follow the same procedure in the
opposite sequence.
8.0 Reasons for operational
problems - troubleshooting
Poor draught
• Check the length of the chimney and that it complies with
national laws and regulations. Make sure that the minimum
cross section on the chimney is large enough. See also «2.0
Technical data» and «4.5 Chimney» for information.
• Make sure that there is not anything preventing the smoke
gasses from escaping: Branches, trees, etc.
The fire extinguishes after a while
• Make sure that the firewood is sufficiently dry
• Make sure that there is no negative pressure in the house. If
there is a negative pressure close mechanical fans and open
a window close to the stove.
• Check that the air vent is open.
• Check that the flue outlet is not clogged by soot
If an unusual amount of soot accumulates
on the glass
Some soot will always stick to the glass, but the quantity depends
on:
• Humidity of the fuel.
• Local draught conditions.
• Regulating the air vent.
Most of the soot will normally burn off when the air vent is
opened all the way and a fire is burning briskly in the fireplace.«6.1
Cleaning the glass - good advice» .
