542987
34
Zoom out
Zoom in
Vorherige Seite
1/52
Nächste Seite
STEP:1
FRONTSUPPORT(FrontStabilizer)Assy
NO PARTS LIST QUANTITY
STEP:2
REARSUPPORT(RearStabilizer)ASSY.
NO PARTS LIST QUANTITY
STEP:3
UPRIGHTTUBEASSY.TOTHEFRAME
NO PARTS LIST QUANTITY
STEP:4
PEDALASSY.
NO PARTS LIST QUANTITY
STEP:5
PEDALSUPPORTTUBEASSY.()
NO PARTS LIST QUANTITY
As photo shown
1) In order to facilitate assembly, use one of the lager styroform set
under the Frame ( as photo shown)
2) Attach the rear support to the frame with two bolts (#19)
washers (#65) nuts #20)
3) locking sleeves with tool and cover the nut with two caps (#21)
As photo shown
1) in order to facilitate assembly, use one of the lager styroform set
under the Frame ( as photo shown)
2) Attach the front support with transportation wheels to the frame with
two bolts (#19) washers (#65) nuts (#20)
3) locking sleeves with tool and cover the nut with two caps (#21)
As photo shown
1) place upright tube on top of a chair ( or by a second person to
assist holding) close to the main frame be facilitated to connect the cables.
2) check the direction of upright tube before connect the Top/Bottom
pre-assembled cables as photo shown.
3) fixing eight screws (#18) with finger locking first then tighten all firmly.
Note! tighten the two screws on the label "" screw hold and
then locking up the rest of six screws.
2
2
#21
#19 2
#65
#20
2
2
#65 2
#20 2
#21 2
#18 6
#19
#22 8
#20 8
#5 2
#12 2
#82 2
#17
2
2
1) Set both pedal tube (R#74/L#75) & plastic pedals(#52/#53)
on the floor, indentity the (R/L) match up left set (#74/#52) &
right set (#75/#53).
Note! the pedal has left/right label, check the diredtion of pedl
for front and foot protection edge of pedal as drawing shown)
2) lock up both pedals to the tube plate with screws(#22), nut (#20),
with tool socket & screw driver firmly ( as drawing showm)
Note! Three sets of holds on the tube plate, user may choice
one set to use, eash set will give one inch variation pedal
distance to select, make sure bothpedals select the same
location of holes
1) Frist, distinguish between the left/right pedal support tube
(note: check pedal support tube with left/right label)
2) Set both pedal support tube (#74&#75) to the main frame
as drawing shown first
3) Insert long bushing (#82) to the axle on main frame (disc),
then inset both pedal trube (#74&#75), insert short bushing (#83)
washer (#1 7), secure each with M10 nylon lock nut (#12)
fully tighten up
4) cover the nut with end cap (#5)
#83
JOYSPORT
www.joysport.nl7
7
34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

joy-sport-ct-explorer-crosstrainer

Suche zurücksetzen



  • Guten Tag. Mein Adapter ist defekt.Möchte wissen was für einen ich brauche? Wieviel Volt ?
    Mit freundlichen Grüßen Eingereicht am 9-4-2019 12:38

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Joy Sport CT-Explorer Crosstrainer wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info