3736
Measuring split times
During the time measurement process it is possible to display a split
time without stopping the stopwatch process. To do this, start measu-
rement using the start-stop pusher (7). To read the split time operate
the reset pusher (11). The time measurement continues in the bak-
kground. Pressing the reset pusher (11) again results in the chronosco-
pe counter advancing rapidly to catch up with the time that has elap-
sed. Stop the chronoscope function by pressing the start-stop pusher
(7) again. To return the chronoscope hands to the zero position, press
the reset pusher (11).
3.6 Alarm
Pull the crown into position B. Now press the reset pusher (11) to set the
alarm time. Press the reset pusher (11) briefly for a single step and lon-
ger for continuous setting, until the required alarm time (5) is display-
ed. To start the alarm push the crown back into position A. Once the
alarm time is reached an acoustic signal is sounded for 20 seconds or
until the start-stop pusher (7) or reset pusher (11) is pushed. After the
alarm has gone off it is no longer active, the current time is displayed
until the next activation. If another alarm is required, please set this as
detailed above. Operating the start-stop pusher (7) in crown position B
results in the alarm tone sounding for the duration of the push.
3.7 Resetting the chronoscope
Following complete discharge of the energy store it is advisable to con-
duct a reset. To do this, pull the crown to position C. Ensure that the
crown is not locked. Operate the start-stop pusher (7) and the reset
pusher (11) simultaneously for at least 2 seconds. Now push the crown
back into position A. The reset is completed, now set the correct time
and date (10).
3.8 Setting the chronoscope counters to zero
If one or more of the chronoscope counters are not in the correct posi-
tion (e.g. following complete discharge of the energy store), these
should be set: pull the crown into position C. Ensure that the crown is
not locked. Now operate the reset pusher (11) to adjust the alarm
hands (5). Operate the reset pusher (11) briefly for a single step and
longer for continuous setting, until the alarm hands (5) display the cur-
rent time. If the adjustment is activated with the alarm activated but
not triggered, the alarm hands (5) will first move to the current time.
To adjust the stop minute hand (2) operate the start-stop pusher (7) for
2 seconds. The hand (2) rotates one full rotation and stops at the start
position. Now operate the reset pusher (11) to adjust the stop minute
hand (2), a short push for minute steps, a longer push for continuous
adjustment. To adjust the stop minute hand (2) operate the start-stop
