Bedienungsanleitung Junker JB33AC51 (Seite 61 von 64) (Deutsch, Englisch, Holländisch, Französisch)

636797

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

Faults and repairs

In the event of a fault, check the tips in the following table

before calling the after-sales service.

: Risk of electric shock!

■ Work on the appliance electronics may only be performed by

a specialist.

■ Always disconnect the appliance from the power supply

when work is carried out on the electronics. Switch off the

circuit breaker or remove the fuse from your household fuse

box.

Replacing the oven light bulb

Replace faulty oven light bulbs.

You can obtain replacement light bulbs from customer service

or specialist retailers: E14, 220 - 240 V, 40 W, heat resistant to

300 °C. Only use these oven light bulbs.

: Risk of electric shock !

Disconnect the appliance from the power supply. Switch off the

circuit breaker or remove the fuse from the household fuse box.

1. Place a tea towel in the cold cooking compartment to prevent

damage.

2. Turn the glass cover anticlockwise and remove it.

3. Replace the oven light bulb with a bulb of the same type.

4. Screw on the glass cover again.

5. Remove the tea towel and switch on the circuit breaker.

Note: If the glass cover cannot be unscrewed: use rubber

gloves to turn it. You can order a special removal tool through

the after-sales service (order no. 613634)

Changing the door seal

If the door seal is defective, it must be replaced. Replacement

seals for your appliance can be obtained from the after-sales

service.

The door seal is attached in four places (figure A). When

replacing it, disconnect and attach the hooks at all four points

(figure B).

Check again to ensure that the seal is seated correctly in the

corners in particular.

After-sales service

In the event of faults and repairs that you cannot rectify yourself,

please use our after-sales service.

You can find the addresses in the after-sales service directory.

Note: You will be charged for calling the after-sales service

regarding an operating error.

When contacting the after-sales service, please specify the E-

number and FD number.

You can find these on the rating plate behind the appliance

door on the left-hand bottom edge.

Problem Possible cause Remedial action

Electrical operation is faulty (e.g. indicator

lamps no longer light up)

Fuse defective Check fuses in the fuse box and replace if

necessary

Liquid or runny dough runs to one side Appliance not installed level Check the appliance installation (see the

Installation instructions)

Smoke is generated during roasting or

grilling

Fat is burning on the grill element Continue grilling or roasting until the fat on

the grill element is burnt away

Wire rack or universal pan inserted incor-

rectly

Check the shelf heights (see section:

Roasting or grilling)

High levels of condensation are generated

in the cooking compartment

Normal occurrence (e.g. when baking

cakes with very moist toppings or roasting

a large joint)

Open the appliance door briefly from time

to time during operation

Enamelled accessories have matt, light-

coloured marks

Normal occurrence caused by dripping

meat or fruit juices

Not possible

Door panels are misted up Normal occurrence caused by tempera-

ture differences

Heat the appliance up to 100 °C and then

switch off again after 5 minutes

E no. FD no.

$ %

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Junker JB33AC51 Seite 61

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info