Bedienungsanleitung Junkers MKB 400-3 A (Seite 45 von 116) (Englisch)

636486

Zoom out

Zoom in

Vorherige Seite

1/116

Nächste Seite

Regulations and operating conditions

6 720 645 817 (2010/09)

6.6 Siting combustion equipment

Subject to the regulations of the relevant country, gas

combustion equipment with a total rated output in

excess of 50 kW may only be installed in rooms:

• that are not used for any other purpose

• that have no opening towards other rooms, except

doors

• the doors of which are tight and self-closing or

• that can be ventilated.

Notwithstanding these rules, combustion equipment

may also be installed in other rooms, if:

• the use of these rooms makes this necessary and the

combustion equipment can be operated safely or

• the rooms are in freestanding buildings that only

serve to operate the combustion equipment and fuel

storage.

Open flue combustion equipment must not be installed:

• in stairwells, except in residential buildings with no

more than two apartments

• in generally accessible hallways that serve as escape

routes or

• in garages.

Rooms with systems that extract air

Open flue combustion equipment must only be installed

in rooms equipped with systems that extract air subject

to the following conditions:

• simultaneous operation of the combustion equipment

and the air extractor systems will be prevented by

safety equipment

• the flue gas routing will be monitored by appropriate

safety equipment or

• flue gas will be routed via the air extractor systems or

it will be ensured that such systems cannot create

dangerous negative pressure.

6.7 Sound insulation

The quiet gas premix burner in the Suprapur generates

only low noise emissions, compared to conventional

pressure-jet gas burners. This generally makes

additional sound insulation measures to ensure airborne

noise inside the installation room superfluous. The

transmission of structure-borne noise is largely

prevented by the standard adjustable feet supplied.

Nevertheless, pumps and other system components can

cause structure-borne noise. Where required, this can

be addressed by the use of compensators and other

measures designed to reduce the transmission of

structure-borne noise. Further on-site measures can be

implemented if the aforementioned measures are

inadequate and more stringent requirements for noise

protection apply.

6.8 Antifreeze

The antifreeze Antifrogen N is approved for use in the

Suprapur series. Observe the manufacturer's

instructions.

When pumping liquids with viscosities that differ from

that of water, the hydraulic performance of pumps and

the pipework will also be different. For further details on

sizing pumps, see the technical guides published by the

pump manufacturers.

For further information on the siting and

installation of gas combustion equipment,

see country-specific regulations. These

must also be observed.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Junkers MKB 400-3 A Seite 45

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info