38
5 Permanent settings in programming mode
You can set whether the switch-on rinse should be started manually
or automatically.
Example: Proceed as follows to specify that the switch-on rinse
should be started automatically after switching on.
k T Keep the Rotary Switch pressed until
RINSE appears.
g T Turn the Rotary Switch until
RINSING is displayed.
k T Press the Rotary Switch to enter the programme item.
MANUAL
g T Turn the Rotary Switch until AUTOMATIC is displayed.
k T Press the Rotary Switch to confirm the setting.
OK appears briefly on the display.
RINSING
g T Turn the Rotary Switch until EXIT is displayed.
k T Press the Rotary Switch to exit programming mode.
READY
In the programme item RESET you can restore various settings to
their factory settings:
Z PRODUCT
U The settings (amount of water, strength, temperature) for
any product can be restored individually to the factory
settings. The corresponding double product is reset at the
same time.
Z ALL PROD.
U The settings (amount of water, strength, temperature) for all
products are restored to the factory settings.
Z RESET ALL
U All customer settings are restored to the factory settings.
The IMPRESSA then switches off.
Example: Proceed as follows to restored the values for
‘Espresso’ to
the factory settings.
k T Keep the Rotary Switch pressed until
RINSE appears.
g T Turn the Rotary Switch until
RESET is displayed.
k T Press the Rotary Switch to enter the programme item.
PRODUCT
Rinsing
Restore factory
settings
