Bedienungsanleitung JVC CA-UXG48 (Seite 36 von 44) (Englisch)

56621

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

Additional Information

Learning More about This System

Connections (see pages 3 to 5)

• Make sure the antenna conductors do not touch any other

terminals, connecting cords or the power cord. Also, keep

the antennas away from metallic parts of the System,

connecting cords, and the power cord. These could cause

poor reception.

• Use only speakers with the same speaker impedance as

indicated by the speaker terminals on the rear of the System.

• The speakers are magnetically shielded to avoid color

distortions on TVs. However, if not installed properly, it

may cause color distortions. So, pay attention to the

following when installing the speakers.

– When placing the speakers near a TV set, turn off the

TV’s main power switch or unplug it before installing the

speakers.

Then wait at least 30 minutes before turning on the TV’s

main power switch again.

– Some TVs may still be affected even though you have

followed the above instructions. If this happens, move

the speakers away from the TV.

Daily Operations—Playback (see pages 7 to 11)

Listening to the Radio:

• If you store a new station into an occupied preset number,

the previously stored station in that number will be erased.

• When you unplug the power cord or if a power failure

occurs, the preset stations will be erased in a few days. If

this happens, preset the stations again.

Playing Back a Disc/USB mass storage class device:

• When you change the source to “DVD/CD” or “USB

MEM,” it may take a while to activate the source.

• While the System is reading a disc, the source may not

change to “USB MEM” properly. In this case, press 7, then

reselect “USB MEM” as the source.

• On some discs, the actual operations may be different from

what is explained in this manual due to the programming

and disc structure; such differences are not a malfunction

of this System.

• The System recognizes up to 150 tracks (files) per group,

and 99 groups per disc/USB mass storage class device. The

total number of tracks (files) that the System can detect is

4000.

– If there are any unplayable files in a folder, those files are

also counted in the total file number.

– Playable files which do not belong to any groups are

handled as GROUP 1.

• For playback of files in the USB mass storage class device...

– When connecting a USB mass storage class device, refer

also to its manual.

– Connect one USB mass storage class device to the

System at a time. Do not use a USB hub.

– You cannot charge any USB mass storage class device

through the USB MEMORY terminal.

– While playing back a file in a USB mass storage class

device, do not disconnect the device. It may cause

malfunction on both the System and the device.

– JVC bears no responsibility for any loss of data in the

USB mass storage class device while using this System.

– This System is compatible with USB 2.0 Full Speed.

– You can play back the following types of files in a USB

mass storage class device (maximum data transfer rate:

2Mbps):

–Music: MP3, WMA, WAV

–Picture: JPEG

–Movie: MPEG-1, MPEG-2, DivX (maximum frame

rate of 30 fps for progressive)

– This System may not play back some files even though

their formats are listed above.

– You cannot play back a file larger than 2 Gigabytes.

– When playing a file of a large transfer rate, frames or

sounds may be dropped during playback.

– This System cannot recognize a USB mass storage class

device whose rating is other than 5 V and does not

exceed 500 mA.

– This System may not play back some USB mass storage

class devices and does not support DRM (Digital Rights

Management).

– It will take some time to start up a digital audio player

whose contents are larger than 1 Gigabyte.

• For DVD-VR playback...

– This System can play only a disc of UDF-Bridge format.

– For details about DVD-VR format and Play List, refer to

the manual of the recording equipment.

• For MP3/WMA/WAV playback...

– MP3/WMA/WAV discs require a longer readout time

than regular CDs. (It depends on the complexity of the

group/file configuration.)

– Some MP3/WMA/WAV files cannot be played back and

will be skipped. This results from their recording

processes and conditions.

– This System can play only a disc of ISO 9660 Level 1 or

Level 2.

– This System can play back MP3/WMA/WAV files with

the extension code <.mp3>, <.wma>, or <.wav>

(regardless of the letter case—upper/lower).

– It is recommended that you make each MP3/WMA/

WAV files as following conditions:

– For MP3/WMA files: At a sample rate of 44.1 kHz and

at a data transfer rate of 128 kbps. This System cannot

play back files made at a bit rate of less than 64 kbps.

– For WAV files: At a sample rate of 44.1 kHz and at a

quantization rate of 16 bit Linear PCM.

UX-G48[B].book Page 33 Friday, June 22, 2007 11:28 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

JVC CA-UXG48 Seite 36

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von JVC CA-UXG48

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info