Bedienungsanleitung JVC DR-MV5 (Seite 37 von 100) (Englisch)

56211

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

Masterpage:Right0

EN 37

Filename [MV5S_08Basic TimerDub.fm]

Page 37Wednesday, 31 August 2005 16:55

EDITING

1 For DVD deck

Load a recordable disc.

● Load an empty disc. If a disc with recorded data is loaded, the time

calculation will not include the recorded section, and so dubbing may

not be possible for an entire tape.

For VHS deck

Load a cassette you want to dub.

2 Press and hold VHS] for more than 2 seconds to start

dubbing.

● The unit fast-forwards and rewinds the tape to calculate the recording

time, then starts dubbing after setting automatically the recording

mode that enables recording to fill exactly one disc. It takes a few

minutes to calculate the recording time.

● After dubbing is completed, the VHS deck rewinds the tape

automatically and the unit shuts off.

● To cancel dubbing, press VHS] again so that “]” lights off.

● To stop dubbing, press 8.

NOTES:

● When you turn on the unit next time, press VHS] so that “]” lights

off before performing any operations. If it is not done, recording on

the DVD deck is not possible.

● It is not possible to dub a tape with a copy protection signal.

● If there is no remaining recording time left on a DVD disc, the tape

automatically stops at that position.

● It is not possible to perform other operations like Live Memory

Playback. Check the recorded programme on the disc after dubbing.

● It is not possible to perform dubbing on the On-Disc Timer

programmed disc. Either cancel the disc programming, or use an

unprogrammed disc.

● If the index code (VISS signal) is found on a tape during One-Touch

Expert Dubbing, a single title is created. While creating a title, the

dubbing stops. Dubbing starts again once the title is created. When a

tape contains multiple VISS signals, separate titles are created for

each VISS signal.

● During still picture on the VHS deck, the images may jitter, but this is

not a malfunction.

One-Touch Expert Dubbing (From VHS

To DVD)

● Turn on the unit.

● Turn on the TV and select the AV mode.

● Slide the TV/DVD switch to DVD.

● Make sure that both the DVD deck and the VHS deck are in the

stop mode.

VHS/DVD

DVDVHS

REC

VHS DVDDUBBING

DV IN

STANDBY/ON

S-VIDEO VIDEO AUDIO

VHS

Auto Recording Mode Optimizer

The unit calculates the total recording time of the VHS tape and

automatically selects the optimum DVD recording mode.

Auto Title Creation Dubbing

Each index code (VISS signal) on the VHS tape is detected and

created as a title on the DVD disc. When a tape contains multiple

VISS signals, separate titles are created for each VISS signal

(for each programme).

Auto Blank-Cut Dubbing

Recording to the DVD pauses during blank sections on the VHS

tape and restarts when a signal is detected.

Stop and pause mode on the DVD deck

When recording, the unit automatically searches for the blank

section of the disc no matter where the disc was stopped or

paused.

In contrast to VHS tapes, recorded sections on discs cannot be

overwritten.

MV5S_00.book Page 37 Wednesday, August 31, 2005 4:55 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

JVC DR-MV5 Seite 37

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von JVC DR-MV5

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info