Bedienungsanleitung JVC FS-SD990R (Seite 15 von 28) (Englisch)

640583

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

Using the Tuner

Presetting Stations

You can preset up to 30 FM stations and up to 15 AM (MW/

LW) stations using the Remote Control.

• Preset numbers may have been set to factory test fre-

quencies prior to shipment. This is not a malfunction. You

can preset the stations you want into memory by following

one of the presetting methods below.

Manual Presetting

Select a band by pressing the FM/AM

button.

Press the

button to tune in a

station.

Press the SET button.

“SET” will blink for 5 seconds.

Within 5 seconds, proceed to the next step.

When the display returns to the one set in step 2 after 5

seconds, press the SET button again.

Press the UP, DOWN, >, or < button

within 5 seconds to select the preset

number.

UP or DOWN button:Increase or decrease the preset

number by 1.

Pressing and holding the button

will continuously increase or de-

crease the preset number.

> or < button: Increase or decrease the preset

number by 1.

Pressing and holding the button

will rapidly increase or decrease

the preset number.

Press the SET button within 5 seconds.

“STORED” appears and after 2 seconds, the display re-

turns to the broadcast frequency display.

Repeat above steps 1 to 5 for each sta-

tion you want to store in memory with a

preset number.

To change the preset stations, repeat the same

steps as above.

Auto Presetting

In each band, you can automatically preset FM-30, AM-15

(MW/LW) stations. Preset numbers will be allocated as sta-

tions are found, starting from the lowest frequency and

moving up the frequency.

Select a band by pressing the FM/AM

button.

Press the AUTO PRESET button on the

Remote Control for more than two sec-

onds.

Repeat steps 1-2 for the other band.

■ If you want to change the preset stations, carry out the

Manual Presetting for the desired preset numbers.

CAUTION:

• Even if the system is unplugged or if the

power failure occurs, the preset stations

will be stored for about 24 hours. However,

in case the preset stations are erased, you

will need to preset the stations again.

To Change the FM

Reception Mode

When you are tuned into an FM stereo broadcast, the

“STEREO” indicator lights up and you can hear stereo ef-

fects.

If an FM stereo broadcast is hard to receive or noisy, you

can select Monaural mode. Reception improves, but you

lose stereo effect.

Press the FM MODE button on the Remote Control

so that the “MONO” indicator lights up on the dis-

play.

To restore the stereo effect, press the FM MODE button

on the Remote Control so that the “MONO” indicator goes off.

SET

DOWN

SET STORED

SET

When changing the

Band

FM = 30, AM = 15

AUTO

PRESET

(for 2 seconds)

MONO

FM MODE

FS-SD550(B).book Page 12 Saturday, January 13, 2001 2:08 PM

Downloaded from www.Manualslib.com manuals search engine

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

JVC FS-SD990R Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von JVC FS-SD990R

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info