Bedienungsanleitung JVC GR-D248 (Seite 30 von 52) (Englisch)

663422

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

MasterPage: Heading0_Left

30 EN

FEATURES FOR RECORDING

LED Light can be used to

brighten the subject in the dark

place during video recording or

D.S.C. shooting.

1 Press LIGHT repeatedly to

change the setting.

OFF: Turns off the light.

ON: The light is on always. ( appears.)

AUTO: The light turns on automatically when

dark. ( appears.)

2 Press the Recording Start/Stop Button to

start video recording or SNAPSHOT to shoot a

still image.

NOTES:

● Be careful not to point the LED Light directly to

eyes.

● If the light does not reach the subject, the Night-

Scope function will be activated, and makes it

possible to shoot the subject brighter.

● There is a difference in the brightness of the

images shot between the centre area which is

illuminated by the LED Light and the surrounding

areas (which will be darker).

● Since subjects are shot at a reduced shutter

speed when the LED Light setting is “ON”, they

will appear slightly blurred.

Record a vacation or an important event in 5-

second clips to keep the action moving. This

function is available only for video recording.

1 Set “5S” to “5S”. (墌 pg. 26)

● The “5S” indicator appears.

2 Press the Recording Start/Stop Button to

start recording, and after 5 seconds the

camcorder enters Record-Standby mode

automatically.

● Even if you press the Recording Start/Stop Button

again within 5 seconds after recording starts,

Record-Standby mode is not engaged.

3 To exit the 5S mode, select “OFF” in step 1.

To take a snapshot in the 5-second recording

mode

Instead of pressing the Recording Start/Stop

Button in step 2, select the desired Snapshot

mode in CAMERA Menu (墌 pg. 25), then press

SNAPSHOT. The camcorder records a 5-

second still. When “5S” is set to “Anim.”, this

function is not available.

NOTE:

When “5S” is set to “Anim.”, the 5-Second

Recording mode is not available. Animation

recording of a few frames only is taken instead.

Makes dark subjects or areas even brighter than

they would be under good natural lighting.

Although the recorded image is not grainy, it may

look as if it is strobing due to the slow shutter

speed.

1 Set the Power Switch to “M”.

2 Press NIGHT so that the Night-Scope

indicator “ ” appears.

● The shutter speed is automatically adjusted to

provide up to 25 times sensitivity.

● “ ” appears beside “ ” while the shutter speed

is being automatically adjusted.

To deactivate Night-Scope

Press NIGHT again so that the Night-Scope

indicator disappears.

NOTES:

● During Night-Scope, the following functions or

settings cannot be activated and its indicator

blinks or goes out:

• Some modes of “Program AE With Special

Effects” (墌 pg. 36).

• “GAIN UP” in CAMERA Menu (墌 pg. 25).

• “DIS” in MANUAL Menu (墌 pg. 26).

● During Night-Scope, it may be difficult to bring the

camcorder into focus. To prevent this, use of a

tripod is recommended.

LED Light

5-Second Recording

LED Light

Night-Scope

GR-D248PAL.book Page 30 Sunday, January 23, 2005 3:38 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

JVC GR-D248 Seite 30

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von JVC GR-D248

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info