Bedienungsanleitung JVC GR-D50 (Seite 34 von 48) (Englisch)

533228

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

TROUBLESHOOTING

The focus does not adjust automatically.

• Focus is set to the Manual mode.

¥ Set Focus to the Auto mode (੬ pg. 19).

• The recording was done in a dark place, or the

contrast was low.

• The lens is dirty or covered with condensation.

¥ Clean the lens and check the focus again

(੬ pg. 38).

The cassette will not load properly.

• The cassette is in the wrong position.

¥ Set it in the right position (੬ pg. 9).

• The battery’s charge is low.

¥ Install a fully charged battery (

੬ pg. 7, 8).

Snapshot mode cannot be used.

• The Squeeze mode is selected.

¥ Disengage the Squeeze mode (੬ pg. 22).

The colour of Snapshot looks strange.

• The light source or the subject does not include white.

Or there are various different light sources behind the

subject.

¥ Find a white subject and compose your shot so that

it also appears in the frame (੬ pg. 18).

• The Sepia or Monotone mode is activated.

¥ Turn off Sepia and Monotone (੬ pg. 16).

The image taken using Snapshot is too dark.

• Shooting was performed under backlit conditions.

¥ Press the BACKLIGHT Button 0 (੬ pg. 19).

The image taken using Snapshot is too bright.

• The subject is too bright.

¥ Set “PROGRAM AE” to “SPOTLIGHT” in the Menu

Screen (੬ pg. 16).

Digital Zoom does not work.

• 16X optical zoom is selected.

¥ Set “ZOOM” to “40X” or “700X” in the Menu Screen

(੬ pg. 21).

The Black & White Fader does not work.

• The Sepia or Monotone mode is activated.

¥ Turn off Sepia and Monotone (੬ pg. 16).

Before consulting your JVC dealer, please check the

following to see it you can correct the problem yourself.

The camcorder is a microcomputer-controlled

device. External noise and interference (from a TV,

a radio, etc.) might prevent it from functioning

properly. In such cases, first disconnect its power

supply unit (battery pack, AC Adapter, etc.) and wait

a few minutes; and then re-connect it and proceed

as usual from the beginning.

No power is supplied.

• The power is not connected properly.

¥ Connect the AC Adapter securely (੬ pg. 7).

• The battery is dead.

¥ Replace the dead battery with a fully charged one

(੬ pg. 7, 8).

“SET DATE/TIME!” appears.

• The date/time is not set.

¥ Set the date/time (੬ pg. 10).

• The built-in clock battery has run out and the

previously set date/time has been erased.

¥ Consult your nearest JVC dealer for replacement.

Recording cannot be performed.

• The tape’s erase protection tab is set to “SAVE”.

¥ Set the tape’s erase protection tab to “REC”

(੬ pg. 9).

• The Power Switch y is set to “PLAY” or “OFF

(CHARGE)”.

¥ Set the Power Switch y to “ ” or “ ” (੬ pg. 12).

• “TAPE END” appears.

¥ Replace with new cassette (੬ pg. 9).

• The cassette holder cover is open.

¥ Close the cassette holder cover.

There is no picture.

• The camcorder is not getting power, or some other

malfunction exists.

¥ Turn the camcorder’s power off and on again

(੬ pg. 12).

01 D50/40/30/20EK 34-48 02.12.4, 19:2234

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

JVC GR-D50 Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von JVC GR-D50

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info