Bedienungsanleitung JVC GR-DV1800 (Seite 17 von 96) (Englisch)

452692

Zoom out

Zoom in

Vorherige Seite

1/96

Nächste Seite

EN17

Self-Recording

JOURNALISTIC SHOOTING

In some situations, different shooting angles may provide

more dramatic results. Hold the camcorder in the desired

position and tilt the LCD monitor in the most convenient

direction. It can rotate 270° (90° downward, 180°

upward).

INTERFACE SHOOTING

The person you shoot can view himself/herself in the LCD

monitor, and you can even shoot yourself while viewing

your own image in the LCD monitor.

Open the LCD monitor and tilt it upward to 180° so that it

faces forward. When the LCD monitor is tilted upward to

an angle of over approx. 105°, the monitor image is

inverted vertically. If the viewfinder is pulled out at that

time, it also switches on.

Point the lens toward the subject (yourself when self-

recording) and start recording.

During Interface Shooting, the monitor image and

indications do not appear inverted as they would when

viewing a mirror.

NOTES:

●

During Interface Shooting, the “Tape Running” indicator

and warning indications (



pg. 87, 88) are the only

ones that are shown; they appear reversed in the display

as they would when viewing a mirror, but are not

reversed in the recording.

●

The tape remaining indicator does not appear during

interface shooting. However, when the remaining time

reaches 2 minutes, the indicator appears showing the

remaining time: (blinking)

(blinking) (blinking)

NOTES:

●

When you use the LCD monitor outdoors in direct sunlight, the LCD monitor may be difficult to see. If this

happens, use the viewfinder instead.

●

The image will not appear simultaneously in the LCD monitor and the viewfinder except during Interface

Shooting.

●

The cassette holder cannot be opened unless a power supply is attached.

●

There may be a delay after you open the cassette holder cover until the cassette holder opens. Do not use force.

●

Once the cassette holder is closed, it recedes automatically. Wait until it recedes completely before closing

the cassette holder cover.

●

The time required to calculate and display the remaining tape length, and the accuracy of the calculation,

may vary according to the type of tape used.

●

“TAPE END” appears when the tape reaches its end, and the power goes off automatically if left in this

condition for 5 minutes. “TAPE END” also appears when a cassette at its end is loaded.

●

If the Record-Standby mode continues for 5 minutes, the camcorder’s power shuts off automatically. To turn

the camcorder on again, push back and pull out the viewfinder again or close and re-open the LCD monitor.

●

When a blank portion is left between recorded scenes on the tape, the time code is interrupted and errors

may occur when editing the tape. To avoid this, refer to “Recording from the middle of a tape” (



pg. 21).

●

During recording, sound is not heard from the speaker. To hear the sound, connect optional headphones to

the PHONE connector. The sound volume is at the level it was adjusted to during playback (



pg. 38).

●

To turn the tally lamp or beep sounds off,



pg. 26, 29.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

JVC GR-DV1800 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von JVC GR-DV1800

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info