452692
88
Zoom out
Zoom in
Vorherige Seite
1/96
Nächste Seite
88 EN
Indications Function
Appears if Insert Editing is attempted on a tape recorded in the LP mode.
( pg. 72)
Appears if INSERT (w) on the remote control is pressed when the erase
protection tab is set to SAVE.( pg. 72)
Appears if the Shooting Mode Switch is set to XGA/VGA or UXGA.
( pg. 14)
Appears when the memory cards memory is full and shooting is not
possible.
Appears if dubbing of copyguarded signals is attempted while this
camcorder is being used as a recorder.
Appears in the following cases when dubbing from a tape to a memory
card:
when no memory card is loaded.
when the memory card's memory is full.
when the memory card is not formatted.
when a copy-protected SD Memory Card is loaded. ( pg. 60)
Appears in the following cases if a memory card is not loaded when
SNAPSHOT is pressed:
when the Power Switch is set to or and the Shooting Mode
Switch is set to XGA/VGA or UXGA.
when the Shooting Mode Switch is set to VIDEO and CAMERA
MODE is set to DUAL in the Menu Screen. ( pg. 19, 24)
Appears when there is a problem with a memory card and its memory is
corrupt, or it has not been initialised. Initialise the memory card .
( pg. 47)
Appears if there is no images stored in the memory card when the Power
Switch is set to and MEMORY PLAY is pressed.
Appears when the camcorder takes more than 60 seconds to recognize the
loaded memory card. Remove the memory card once and insert it again.
Repeat these procedures until no indication appears. If the indication still
appears, the memory card is corrupted.
Appears when you attempt to shoot digital still images while a copy-
protected SD Memory Card is loaded.
The error indications (E01 E06) show what type of malfunction has
occured. When an error indication appears, the camcorder turns off
automatically. Remove the power supply (battery, etc.) and wait a few
minutes for the indication to clear. When it does, you can resume using the
camcorder. If the indication remains, consult your nearest JVC dealer.
PLEASE
FORMAT
MEMORY CARD!
E01 E06
UNIT IN SAFEGUARD
MODE REMOVE AND
REATTACH BATTERY
COPYING FAILED
INDEX
Indications (cont.)
NO IMAGES STORED
CARD ERROR!
CHECK CARDS WRITE
PROTECTION SWITCH
MEMORY IS FULL
INSERT ERROR!
<CANNOT EDIT
ON A LP RECORDED
TAPE>
<CHECK TAPES ERASE
PROTECTION TAB>
<CHECK SHOOTING
MODE SWITCH>
88

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für JVC GR-DV1800 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von JVC GR-DV1800

JVC GR-DV1800 Bedienungsanleitung - Holländisch - 96 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info