Bedienungsanleitung JVC GR-DVL367 (Seite 12 von 88) (Englisch)

39744

Zoom out

Zoom in

Vorherige Seite

1/88

Nächste Seite

GETTING STARTED

(cont.)

Loading/Unloading A Cassette

The camcorder needs to be powered up to load or

eject a cassette.

1 Slide and hold OPEN/EJECT in the direction of

the arrow then pull the cassette holder cover open

until it locks. The cassette holder opens automatically.

• Do not touch internal components.

2 Insert or remove a tape and press “PUSH HERE”

to close the cassette holder.

• Once the cassette holder is closed, it recedes

automatically. Wait until it recedes completely before

closing the cassette holder cover.

• When the battery’s charge is low, you may not be

able to close the cassette holder cover. Do not apply

force. Replace the battery with a fully charged one

before continuing.

3 Close the cassette holder cover firmly until it

locks into place.

Tape

Recording mode

SP LP

30 min. 30 min. 45 min.

60 min. 60 min. 90 min.

80 min. 80 min. 120 min.

Approximate recording time

* To Protect Valuable Recordings . . .

....

slide the erase protection tab on the back of the

tape in the direction of “SAVE”. This prevents the

tape from being recorded over. To record on this

tape, slide the tab back to “REC” before loading it.

Be sure to press only the section labeled “PUSH

HERE” to close the cassette holder; touching other

parts may cause your finger to get caught in the

cassette holder, resulting in injury or product damage.

NOTES:

● It takes a few seconds for the cassette holder to open. Do not apply force.

● If you wait a few seconds and the cassette holder does not open, close the cassette holder cover and try again. If the

cassette holder still does not open, turn the camcorder off then on again.

● If the tape does not load properly, open the cassette holder cover fully and remove the cassette. A few minutes later,

insert it again.

● When the camcorder is suddenly moved from a cold place to a warm environment, wait a short time before opening the

cassette holder cover.

● Closing the cassette holder cover before the cassette holder comes out may cause damage to the camcorder.

● Even when the camcorder is switched off, a cassette can be loaded or unloaded. After the cassette holder is closed

with the camcorder switched off, however, it may not recede. It is recommended to turn the power on before loading or

unloading.

● When resuming recording, once you open the cassette holder cover a blank portion will be recorded on the tape or a

previously recorded scene will be erased (recorded over) regardless of whether the cassette holder came out or not.

See page 20 for information about recording from the middle of a tape.

● Loosen the Grip Strap if it appears to interfere with the cassette holder cover operation (

੬ pg. 10).

OPEN/EJECT

Switch

Cassette holder

PUSH HERE

Cassette holder cover

Make sure the

window side is

facing out.

Erase protection tab*

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

JVC GR-DVL367 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von JVC GR-DVL367

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info