Bedienungsanleitung JVC GR-DVL9200 (Seite 51 von 68) (Englisch)

584571

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

EN51

SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION

TROUBLESHOOTING

No power is supplied.

“SET DATE/TIME!” appears.

Recording cannot be

performed.

There is no picture.

Some functions are not

available using MENU/

BRIGHT.

The focus does not adjust

automatically.

The cassette will not load

properly.

In the 5-Second mode,

recording ends before

5 seconds have elapsed.

Snapshot mode cannot be

used.

• The power is not connected

properly.

• The battery is dead.

• The LCD monitor is not open

fully or the viewfinder is not

pulled out when recording.

• The built-in clock’s recharge-

able lithium battery is

discharged.

• The previously set date/time is

erased.

• The tape’s erase protection tab

is set to “SAVE”.

• The Power Switch is set to

“ ” or “OFF”.

• “TAPE END” appears.

• The cassette holder cover is

open.

• The camcorder is not getting

power, or some other

malfunction exists.

• The Power Switch is set to

“ ”.

• Focus is set to “MANUAL”.

• The recording was done in a

dark place, or the contrast was

low.

• The lens is dirty or covered

with condensation.

• The cassette is in the wrong

position.

• The battery’s charge is low.

• The 5-Second mode is set to

“ANIM.” in the Menu Screen.

• The Squeeze mode is selected.

• Connect the AC Power

Adapter/Charger securely

(Z pg. 7).

• Replace the dead battery with

a fully charged one

(Z pg. 6, 7).

• Open the LCD monitor fully

or pull out the viewfinder.

• Connect the camcorder to an

AC outlet using the AC Power

Adapter/Charger for over 24

hours to charge the clock’s

lithium battery (Z pg. 8).

• Set the tape’s erase protection

tab to “REC” (Z pg. 9).

• Set the Power Switch to “5S”,

“ ” or “ ” (Z pg. 12).

• Replace with new cassette

(Z pg. 9).

• Close the cassette holder

cover.

• Turn the camcorder’s power

off and on again (Z pg. 12).

• Set the Power Switch to “ ”

(Z pg. 12).

• Set Focus to “AUTO”

(Z pg. 28).

• Clean the lens and check the

focus again (Z pg. 57).

• Set it in the right position

(Z pg. 9).

• Install a fully charged battery

(Z pg. 6, 7).

• Select “5S” or “5SD” in the

Menu Screen (Z pg. 18, 20).

• Disengage the Squeeze mode

(Z pg. 18, 19).

If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC dealer.

The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio,

etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery

pack, AC Power Adapter/Battery Charger, etc.) and wait a few minutes; and then re-connect it and proceed

as usual from the beginning.

CONTINUED ON NEXT PAGE

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

JVC GR-DVL9200 Seite 51

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info