Bedienungsanleitung JVC GR-DVP8 (Seite 15 von 84) (Englisch)

533257

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

EN 15

Master Page: Right

The camcorder needs to be powered up to load or

eject a cassette.

1 Slide down and hold OPEN/EJECT in the

direction of the arrow, then pull the cassette

holder cover open until it locks. The cassette

holder opens automatically.

● Do not touch internal components.

2 Insert or remove a tape and press “PUSH HERE”

to close the cassette holder.

● Be sure to press only the section labelled

“PUSH HERE” to close the cassette holder;

touching other parts may cause your finger to

get caught in the cassette holder, resulting in

injury or product damage.

● Once the cassette holder is closed, it recedes

automatically. Wait until it recedes completely

before closing the cassette holder cover.

● When the battery pack’s charge is low, you

may not be able to close the cassette holder

cover. Do not apply force. Replace the battery

pack with a fully charged one or use AC power

before continuing.

3 Close the cassette holder cover firmly until it

locks into place.

To protect valuable recordings…

Slide the erase protection tab on the back of the tape

in the direction of “SAVE”. This prevents the tape

from being recorded over. To record on this tape,

slide the tab back to “REC” before loading it.

Approximate recording time

To switch the recording mode, refer to pages 31 and

34.

NOTES:

● It takes a few seconds for the cassette holder to

open. Do not apply force.

● If you wait a few seconds and the cassette holder

does not open, close the cassette holder cover and

try again. If the cassette holder still does not open,

turn the camcorder off then on again.

● If the tape does not load properly, open the

cassette holder cover fully and remove the

cassette. A few minutes later, insert it again.

● When the camcorder is suddenly moved from a

cold place to a warm environment, wait a short

time before opening the cassette holder cover.

● Closing the cassette holder cover before the

cassette holder recedes may cause damage to the

camcorder.

● Even when the camcorder is switched off, a

cassette can be loaded or unloaded. After the

cassette holder is closed with the camcorder

switched off, however, it may not recede. It is

recommended to turn the power on before

loading or unloading.

● When resuming recording, once you open the

cassette holder cover a blank portion will be

recorded on the tape or a previously recorded

scene will be erased (recorded over) regardless of

whether the cassette holder came out or not. See

“Recording From The Middle Of A Tape”

(੬ pg. 19).

Loading A Cassette

/Unloading A Cassette

Make sure the

window side is

facing out.

Cassette holder cover

Cassette holder

PUSH HERE

OPEN/EJECT Switch

Erase protection tab

Tape

Recording mode

SP LP

30 min. 30 min. 45 min.

60 min. 60 min. 90 min.

80 min. 80 min. 120 min.

GETTING STARTED

GR-DVP9-8PAL.book Page 15 Friday, February 7, 2003 12:35 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

JVC GR-DVP8 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info