39776
30
Zoom out
Zoom in
Vorherige Seite
1/100
Nächste Seite
30 EN
1
D
S
5
T
W
W
F
F
R
I
E
S
E
I
I
L
L
E
S
L
L
D
N
A
A
M
T
F
E
E
D
S
S
A
U
H
H
N
R
T
M
M
C
U
N
I
A
O
U
A
A
M
C
D
T
D
L
E
R
E
J
R
O
.
ME
A
A
O
O
N
U
U
N
F
U
T
T
F
O
O
RECORDING
Advanced Features For Video And D.S.C. (cont.)
Snapshot Flash
The flash can be used when a snapshot is taken in Record-
Standby ( pg. 18, 19).
In Full Auto mode, the flash automatically fires if it is
dark ( appears).
In Manual mode, you can select the FLASH setting as
follows:
AUTO : Fires automatically if it is dark ( appears).
AUTO : Fires automatically if it is dark ( appears)
and reduces the Red-Eye effect in the subjects
eyes.
ON : Always fires.
OFF : Will not fire.
Perform the procedure below.
1
Set the Operation Switch to and set the POWER
Switch to while pressing down the Lock
Button located on the switch, then pull out the
viewfinder or open the LCD monitor fully.
2
Press the MENU wheel. The Menu Screen appears.
3
Rotate the MENU wheel to select , and press it.
MANUAL MENU appears.
4
Rotate the MENU wheel to select FLASH, and press
it. The Sub Menu appears.
5
Rotate the MENU wheel to select AUTO, AUTO
, ON or OFF, and press it. Rotate the MENU
wheel to select
1
RETURN. Press it twice to close
the Menu Screen.
If AUTO Is Selected . . .
.... the Red-Eye reduction indicator lights. Press
SNAPSHOT. The flash fires twice. The first flash is for
reduction of the human eyes red reflection and the
second flash is for the actual recording.
Display
NOTES:
Do not fire the flash at a person at short range.
The flash does not fire when the flash is set to OFF in the Menu Screen, and also when the battery
remaining power is low. Moreover, the flash does not fire when it is set to AUTO in the Menu Screen with
GAIN UP set to OFF (
pg. 27) and with Programme AE with special effects set to TWILIGHT
(
pg. 36).
When taking several snapshots in succession (Motor Drive Mode), the flash fires only during the first one.
Although images shot with a flash tend to look whiter than they actually are, to compensate for this the
camcorder automatically darkens the picture when using the flash. When shooting a subject at a distance
where the flash light cannot reach (over approx. 2 m), push down the flash to prevent the picture from
becoming too dark or becoming too tinted.
The colour tone changes depending on the background lighting conditions, such as under fluorescent or
halogen lamps.
To change the brightness of the flash,
Flash Brightness Adjustment (
pg. 31).
While charging the flash, blinks and the flash will not fire. Although noise may appear, this is not a
malfunction and is not recorded. It can take up to 10 seconds to charge the flash.
SNAPSHOT Button
POWER Switch
Operation Switch
Menu Screen
MENU Wheel
Lock Button
30

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für JVC GR-DVX10 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von JVC GR-DVX10

JVC GR-DVX10 Bedienungsanleitung - Holländisch - 100 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info