Bedienungsanleitung JVC GR-DVX2 (Seite 19 von 84) (Englisch)

595802

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

EN 19

Basic Recording

You should already have performed the necessary preparations (Z pgs. 8 – 16). Set the Power Dial to “

”

and try recording that way before attempting to use more advanced features.

NOTE:

Before starting recording, make sure you set the date and time (

pg. 11). Even if they don’t appear during

recording, you can display them during playback (

pg. 53).

SELECT OPERATION MODE

Set the Power Dial to “

” while pressing down

the lock button located on the dial.

PULL OUT VIEWFINDER OR OPEN

LCD MONITOR

Pull out the viewfinder fully or open the LCD

monitor to approx. 90° degrees.

•The lens cover opens, the power lamp comes

on and the scene you're aimed at appears.

•The Record-Standby mode is engaged.

START RECORDING

When “PAUSE” appears, press START/STOP. A

beep signals the start of recording.

STOP RECORDING

Press START/STOP again to stop recording.

•The camcorder re-enters Record-Standby mode.

END RECORDING

When you’re finished recording, push back the

viewfinder or close the LCD monitor until it

clicks; the lens cover closes and the power

lamp goes out.

•When transporting, make sure the viewfinder

is pushed back and the LCD monitor is

closed and locked.

•To turn power on again, pull out the

viewfinder or open the LCD monitor.

Set the Power Dial to “OFF”.

•When turning to “OFF”, it is not necessary to

press down the lock button.

NOTES:

●

The image will not appear simultaneously in the

LCD monitor and the viewfinder. No image

appears on the LCD monitor when the viewfinder

is pulled out. It is not possible to shoot using both

LCD monitor and viewfinder.

●

If 5 minutes elapse in the Record-Standby mode,

power shuts off automatically to conserve energy

and protect the heads. To turn the camcorder on

again, push back and pull out the viewfinder

again or close and re-open the LCD monitor. As

long as you don’t take out the tape you were

using or play it back, you can continue from

where you left off with no noticeable break on the

recorded video.

●

When a blank portion is left between recorded

scenes on the tape, the time code is interrupted

and errors may occur when editing the tape.

Continue recording from where you stop so there

are no gaps by following "Recording from the

middle of a tape" (

pg. 20).

●

Recored-Standby means that a tape is loaded and

the camcorder is ready to record.

●

During recording, sound is not heard from the

speaker. If you want to hear the sound, connect

optional headphones to the headphones jack. The

sound volume at this point is the same as the level

it was adjusted during playback.

●

To make the indications disappear, press and hold

the IND.ON/OFF button for more than approx. 1

second. However, it is impossible to remove the

tape running indicator “

444

” and warning

indications and so on (

pg. 76).

●

Use the viewfinder when under direct sunlight or

when reflections make it difficult to see the LCD

monitor.

PAUSE

OFF

444

REC

Lock button

Power Dial

Display

Record-Standby

During recording

Power lamp

START/STOP button

RECORDING

IND. ON/OFF

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

JVC GR-DVX2 Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info