Bedienungsanleitung JVC GY-DV500 (Seite 9 von 96) (Englisch)

34423

Zoom out

Zoom in

Vorherige Seite

1/96

Nächste Seite

1. INTRODUCTION

Head drum

Video tape

Monitor screen

Smear

(Vertical pale streaking

appearing at high

luminous object)

High luminous object

(Electric light, sunlight, etc.)

Blooming

(Blurring in highlight)

The GY-DV500 can use any of the following battery packs.

●

Flat shape type

●

Anton-Bauer battery pack: Trimpack 13/14 Series

Magnum 13/14 Series

Compack 13/14 Series

Propack 13/14 Series

* An Anton-Bauer battery pack cannot be connected directly

to the camera. It is necessary to mount the optional battery

holder.

●

Battery holder: Anton-Bauer QRQ27

For details on how to mount the battery holder, see page

37.

●

If the unit has been cooled down in a cold place and is then

carried to a warm place, the moisture contained in the warm

air may adhere to the head drum or tape guides and be cooled

into water droplets. This phenomenon is referred to as

condensation (dewing). When this occurs, the head drum and

tape guides are covered with droplets allowing the tape to be

stuck to them, leading to tape damage.

●

Condensation occurs in the following cases:

●

When condensation occurs in this unit, the DEW indicator

on the display lights up, and the WARNING LED blinks red.

(See page 86)

To remedy, leave the unit with the power ON and wait until

the WARNING LED stops blinking red and the DEW indicator

disappears from the counter display.

• When the unit is suddenly

moved from a cold place to a

warm place.

• When a room heater has just

started or when the unit is

exposed directly to cold air from

an air conditioner.

• When the unit is placed in a very

humid place.

1-5 Battery Pack to be Used

To display the remaining battery power accurately, set the

VCR Setup Menu item No. 396 BATTERY TYPE according

to the type of the battery pack in use. (See page 69)

1-6

Condensation

Smear and Blooming

Due to the physical structure of a CCD it is possible to induce

vertical streaking (called "smear") when shooting an extremely

bright light source. Another effect is the expansion of light around

a bright light or object (called "blooming").

The CCD employed in this unit is characterized by inducing

very little smear or blooming. Nevertheless, please be careful

when shooting a bright light source.

Moire or Aliasing

Shooting stripes or fine patterns may cause a jagged effect or

a banding in fine mesh patterns.

White dots

High temperatures can cause CCD sensor pixels to malfunction

with the effect of white dots in the image. This condition is

conspicuous especially when gain is applied.

This is a characteristic of the charged-coupled device (CCD).

As far as possible, use the unit under conditions where the

temperature of the unit does not increase.

1-7 Characteristic CCD Phenomena

DEW

indicator

AUD LOCK

32k

CH 1

CH 2

48k

PB NDF

AUTO OFF DEW

HOLD

OVER

40 30 20 10 0

OPERATE/WARNING

Do not leave the videocassette inserted when moving the

camera under conditions where the temperature

environment changes.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

JVC GY-DV500 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info