40755
25
Zoom out
Zoom in
Vorherige Seite
1/33
Nächste Seite
25
TROUBLESHOOTING
Before requesting service for a problem, use this chart and see if you can repair the trouble yourself. Small problems are often easily
corrected, and this can save you the trouble of sending your video recorder off for repair.
POWER
POSSIBLE CAUSE
The mains power cord is discon-
nected.
“ is displayed on the display
panel.
SYMPTOM
1. No power is applied to the
recorder.
2. The clock is functioning properly,
but the recorder cannot be
powered.
CORRECTIVE ACTION
Connect the mains power cord.
Press the TIMER button to turn the
“ indicator off.
SYMPTOM
1. The tape does not run during
recording.
2. The tape will not rewind or fast-
forward.
CORRECTIVE ACTION
Press PLAY to turn the “^“ indicator
off.
Check the cassette.
TAPE TRANSPORT
POSSIBLE CAUSE
^“ is displayed on the display
panel.
The tape is already fully rewound or
fast-forwarded.
SYMPTOM
1. The playback picture does not
appear while the tape is running.
2. Noise appears during visual search.
3. Noise appears during normal
playback.
4. Noise appears during slow-motion
playback.
5. Noise appears during still play-
back.
6. The playback picture is blurred or
interrupted while TV broadcasts are
clear.
PLAYBACK
POSSIBLE CAUSE
If you’re using the RF OUT connec-
tion, the TV receivers channel
selector is set to the wrong video
channel.
If you’re using the AV connection,
the TV receiver is not set to the AV
mode.
This is normal.
The automatic tracking mode is
engaged.
The automatic tracking mode is
engaged.
The video heads may be dirty.
CORRECTIVE ACTION
If you are using the RF OUT connec-
tion, set the TV receiver to the RF
converter channel (UHF 36). ( pg. 3)
If you are using the AV connection,
set the TV to its AV mode.
Try manual tracking. ( pg. 11)
Try manual tracking. ( pg. 11)
Press PAUSE a few times to remove
the noise bars from the screen.
Consult your JVC dealer.
CORRECTIVE ACTION
Insert a cassette, or using adhesive
tape, reseal the slot where the tab
was removed.
Set to the desired channel.
POSSIBLE CAUSE
There is no cassette loaded, or the
cassette loaded has had its Record
Safety tab removed.
“AU” has been selected as the input
mode.
SYMPTOM
1. Recording cannot be started.
2. TV broadcasts cannot be recorded.
RECORDING
CONTINUED ON NEXT PAGE.
25

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für JVC HR-A233E wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info