Bedienungsanleitung JVC HR-J270 (Seite 50 von 56) (Englisch)

584566

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

SUBSIDIARY INFORMATION (cont.)

Before requesting service for a problem, use this chart to see if you can correct the trouble yourself. Small problems are often easily

corrected, and this can save you the trouble of sending your video recorder off for repair.

POSSIBLE CAUSE

● The mains power cord is disconnected.

● “‰“ is displayed on the display

panel with Auto Timer set to "OFF".

● The batteries are discharged.

SYMPTOM

1. No power is applied to the recorder.

2. The clock is functioning properly,

but the recorder cannot be powered.

3. The remote control won’t function.

CORRECTIVE ACTION

Connect the mains power cord.

Press the ‰ button to turn the “‰“

indicator off.

Replace the dead batteries with new

ones.

SYMPTOM

1. The tape does not run during

recording.

2. The tape will not rewind or fast-

forward.

CORRECTIVE ACTION

Press PLAY to turn the “ “ indicator

off.

Check the cassette.

SYMPTOM

1. The playback picture does not

appear while the tape is running.

2. Noise appears during visual search.

3. Noise appears during normal

playback.

4. The playback picture is blurred or

interrupted while TV broadcasts are

clear or "USE CLEANING

CASSETTE" message appears on the

screen.

5. Breaks are noticeable in Hi-Fi

soundtrack. (HR-J670/672EK only)

POSSIBLE CAUSE

● If you’re using the RF connection . . .

. . . the TV receiver’s channel selector

is not set to the VIDEO channel.

. . . the recorder's VIDEO channel

has not been correctly set.

● If you’re using the AV connection, the

TV receiver is not set to the AV mode.

● This is normal.

● The automatic tracking mode is

engaged.

● The video heads may be dirty.

● Automatic tracking is engaged.

CORRECTIVE ACTION

If you are using the RF connection . . .

. . . set the TV receiver to the VIDEO

channel. (Z pg. 6)

. . . Perform "Video Channel Set"

(Z pg. 40)

If you are using the AV connection, set

the TV to its AV mode.

Try manual tracking (Z pg. 28).

Use a dry cleaning cassette JVC

TCL-2U or consult your JVC dealer.

Engage and adjust tracking manually

(Z pg. 28) or press AUDIO to

change the soundtrack to "NORM"

(Z␣ pg.␣ 25).

POSSIBLE CAUSE

● “ “ is displayed on the display

panel.

● The tape is already fully rewound or

fast-forwarded.

CORRECTIVE ACTION

Insert a cassette, or using adhesive

tape, reseal the slot where the tab

was removed.

Set to the desired preset.

Confirm that the source is properly

connected.

Confirm that all units’ power switches

are turned on.

Set the input mode to “L-1”,“L-2” or

“F-1”. (“F-1” is for HR-J670/672EK only.)

POSSIBLE CAUSE

● There is no cassette loaded, or the

cassette loaded has had its Record

Safety tab removed.

● “L-1”, “L-2”, “SAT” or “F-1” has

been selected as the input mode.

(“F-1” is for HR-J670/672EK only.)

● The source (another video recorder,

camcorder) has not been properly

connected.

● All necessary power switches have

not been turned on.

● The input mode is not correct.

SYMPTOM

1. Recording cannot be started.

2. TV broadcasts cannot be recorded.

3. Tape-to-tape editing is not possible.

Troubleshooting

POWER

TAPE TRANSPORT

PLAYBACK

RECORDING

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

JVC HR-J270 Seite 50

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info