Bedienungsanleitung JVC HR-S7722EU (Seite 43 von 68) (Englisch)

655781

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

Masterpage:Right-NoTitle0

Filename [HRS7700EU2.fm]

Page 43 March 9, 2000 3:46 pm

Make connections.

Connect the player’s VIDEO OUT or S-VIDEO OUT and

AUDIO OUT connectors to your recorder’s VIDEO or

S-VIDEO and AUDIO input connectors on the front

panel.

Set the recorder’s input mode.

Press

AUX

(

NUMBER

key “

”) and/or

to select “F-1”

for the AUDIO and VIDEO input connectors or “S-1” for

AUDIO and S-VIDEO input connectors.

Locate the end point.

Load the recording cassette into your recorder, and play it

back to determine the edit-out point (the end of the

segment to be replaced) using the

SHUTTLE

ring or the

JOG

dial, or pressing

and

Reset the counter.

Press

0000

●

The counter is reset to “0:00:00”.

Locate the start point.

Determine the edit-in point (the beginning of the segment

to be replaced) using the

SHUTTLE

ring or the

JOG

dial,

or pressing

and

●

Be sure to engage the Still mode at the edit-in point.

Engage the Insert Editing mode.

Press

INSERT

●

Your recorder enters the Insert Pause mode. (“

o”, “u” and

“

i” light up on the front display panel.)

●

The TV screen changes from the still picture to the input

source you are going to record.

Start Editing.

Load the source cassette and play back the segment that

is to be inserted. When you reach the start of the section

of the source tape that you wish to insert, press

to start

the tape in your recorder; Insert Editing begins at this

point.

●

“

o” and “u” are displayed on the front display panel.

End Insert Editing.

At counter “0:00:00”, Insert Editing will stop

automatically while the tape continues running in the

Play mode. If you wish to stop Insert Editing before the

specified edit-out point, press

0000

AV Insert Editing

If you want to replace the picture, Hi-Fi audio soundtrack

and normal audio soundtrack all at the same time ...

... In step

, after you press

INSERT

, press

A.DUB

also.

(“

” and “

” blink and “

” lights up on the front display

panel.)

NOTES:

●

All necessary cables can be obtained from your dealer.

●

Insert Editing is not possible with cassettes whose record safety

tab has been removed.

●

When Insert Editing is performed on a tape that has been

recorded on another video recorder, the inserted portion may

appear distorted.

●

In Insert Editing, the recording speed (SP/LP) is determined by

the previous recording to be replaced. If the previous

recording’s speed changes within a single edit, the inserted

picture will be distorted at the switching point.

●

A small portion of the recording which precedes an insert edit

may become erased.

●

Insert Editing is also possible using the rear panel AV1 (L-1) IN/

OUT or AV2 (L-2) IN/DECODER connector. When using these

21-pin SCART connectors, be sure to select the correct input

mode (“L-1” or “L-2”) in step 2.

HRS7700EU2.fm Page 43 Thursday, March 9, 2000 3:46 PM

Downloaded from www.Manualslib.com manuals search engine

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

JVC HR-S7722EU Seite 43

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info