Bedienungsanleitung JVC hx z 3 r (Seite 29 von 36) (Englisch)

158775

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Continued I_

UsingRecordingTimer

With Recording Timer, you can make a tape of a radio

broadcast automatically.

HowRecordingTimer actuallyworks

The unit automatically turns on, tunes in to the specified

station, sets the volume level to "VOLUME MIN," and starts

recording when the on-time comes. ("REC" and the REC

indicator flash just before the on-time, and the REC indicator

continues flashing while the timer is operating). Then, when

the off-time comes ("REC OFF" appears just before the off-

time), the unit automatically turns off (on standby).

The timer setting remains in memory until you change it.

• There is a time limit in doing the following steps. If the setting

is canceled before you finish, start from step ,2again.

• To correct a misentry while setting the timer, press

CANCEL/DEMO.

On the unit ONLY:

1 Insert a recordable cassette with the exposed

part of the tape down.

2 Press CLOCK/TIMER _o_

repeatedly until "REC"

appears on the display.

The @ (Timer) indicator lights up andthe REC (Recording

Timer) indicator also starts flashing on the display.

PE[

• Each time you press the button, the timer setting modes

change as follows:

DAILY "-_ TIMER --"

_" (Daily Timer setting) j

L_ Canceled --,- Clock 4- TIMER

setting (Recording Timer setting)

(The hour digits start flashing.)

3 Press CLOCK/TIMER again.

"TIMER" appears for 2 seconds, then the

unit enters on-time setting mode.

A AAAA

I--II_I I_II_d I I--I

I_II_I I I I LI

TTTT

4 Set the on-time you want the

unit to turn on at.

1) Turn _ / _ to set the hour, then

press SET/DISPLAY.

"SET" appears for 1 second.

2) Turn _ / _ to set the minute,

then press SET/DISPLAY.

"SET" appears for 1 second, then

the unit enters off-time setting mode.

SET/

DISPLAY

uFF ,,, u

TTTTT

5 Set the off-time you want the unit to turn off

(on standby) at.

1) Turn _ / _ to set the hour, then press

SET/DISPLAY.

"SET" appears for 1 second.

2) Turn _ / _ to set the minute, then press

SET/DISPLAY.

"SET" appears for 1 second, then the unit enters preset

station selecting mode.

6 Select the preset station.

1) Turn _ / _ to select the band ("TUNER FM" or

"TUNER AM"), then press SET/DISPLAY.

"SET" appears for 1 second.

2) Turn _ / _ to select a preset channel number,

then press SET/DISPLAY.

The REC (Recording Timer) indicator stops flashing

and remains lit. "OK _/" appears on the display for

2 seconds.

The settings you have done are shown on the display

in sequence for your confirmation.

7 Press Oil to turn off the unit (on

standby) if necessary.

• If you want to listen toanother source whilerecording

PressREC START/STOPor• to stop recording. Without

stopping it, you cannot change thesource.

• Even ifyou unplug theAC power cord or if apower failure

occurs

Once you set the timer, thetimersetting may remain stored in

memoryfor afew days. In thiscase, checkwhether the timer

setting still remains or not.

- 26 -

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

JVC hx z 3 r Seite 29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info