167162
10
Zoom out
Zoom in
Vorherige Seite
1/194
Nächste Seite
10
ENGLISH
Manual preset
You can preset up to 6 stations in each band
(FM1, FM2, FM3 and AM) manually.
Ex.: Storing an FM station of 88.3 MHz into the
preset number 1 of the FM1 band
1
Select the band (FM1 – 3, AM) you
want to store stations into (in this
example, FM1).
1 Press SOURCE
repeatedly to select FM
as the source.
2 If necessary, press and
hold M/B (mode/band) for
more than 1 second
repeatedly to select FM1.
Each time you press and
hold the button, the FM
band changes as follows:
2
Tune into a station of 88.3 MHz.
3
Press and hold the number button (in
this example, 1) for more than 2
seconds.
4
Repeat the above procedure to store
other stations into other preset
numbers.
Notes:
A previously preset station is erased when a new station
is stored in the same preset number.
Preset stations are erased when the power supply to the
memory circuit is interrupted (for example, during
battery replacement). If this occurs, preset the stations
again.
Tuning into a preset station
You can easily tune into a preset station.
Remember that you must store stations first. If
you have not stored them yet, see “Storing
stations in memory” on page 9.
1
Select the band (FM1 – 3, AM).
1 Press SOURCE
repeatedly to select FM or
AM as the source.
2 If necessary, press M/B
(mode/band) for more
than 1 second
repeatedly to select the
FM band number. Each
time you press and hold
the button, the FM band
changes as follows:
2
Select the number (1 – 6) for the preset
station you want.
If the sound quality decreases and the
stereo effect is lost while listening to
an FM station...
In some areas, adjacent stations may interfere
with each other. If such interference occurs,
this unit can automatically reduce the
interference noise (the initial setting when
shipped from the factory). However, in this
case, the sound quality will be degraded and
the stereo effect will also be lost.
If you do not want to degrade the sound quality
and to lose the stereo effect, rather than to
eliminate the interference noise, see “To
change the FM tuner selectivity – IF FILTER”
on page 33.
Press ¢ to tune
into stations of higher
frequencies.
“P1” flashes for a while.
FM 1 FM 2 FM 3
Press 4 to tune
into stations of lower
frequencies.
FM 1 FM 2 FM 3
EN08-10.KD-SH99R[E]f 4/17/01, 12:32 PM10
10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für JVC kd sh 99 r wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info