Bedienungsanleitung JVC KW-V255DBT (Seite 45 von 60) (Englisch)

682978

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

Installation and Connection Installation and Connection

WARNINGS

• DO NOT connect the ignition wire (red) and the

battery wire (yellow) to the car chassis (ground), you

may cause a short circuit, that in turn may start a fire.

• DO NOT cut out the fuse from the ignition wire (red)

and the battery wire (yellow). The power supply must

be connected to the wires via the fuse.

• Always connect the ignition wire (red) and the

battery wire (yellow) to the power source running

through the fuse box.

CAUTIONS

• Install this unit in the console of your car.

• Do not touch the metal parts of this unit during and

shortly after the use of the unit. Metal parts such as

the heat sink and enclosure become hot.

Before installation

Precautions on installation and connection

• Mounting and wiring this product requires skills and

experience. For best safety, leave the mounting and

wiring work to professionals.

• Mount the unit so that the mounting angle is 30° or

less.

• Make sure to ground the unit to a negative 12V DC

power supply.

• Do not install the unit in a location exposed to direct

sunlight or excessive heat or humidity. Also avoid

places with too much dust or the possibility of water

splashing.

• Do not use your own screws. Use only the screws

provided. If you use the wrong screws, you could

damage the unit.

• After the unit is installed, check whether the brake

lamps, blinkers, wipers, etc. on the car are working

properly.

• Do not press hard on the panel surface when

installing the unit to the car. Otherwise scratches,

damage, or failure may result.

• If the power is not turned on (“Miswiring DC Offset

Error”, “Warning DC Offset Error” is displayed),

the speaker wire may have a short circuit or have

touched the chassis of the car and the protection

function may have been activated. In this case, the

speaker wire should be checked.

• Keep all cables away from heat dissipating metal

parts.

• If your car’s ignition does not have an ACC position,

connect the ignition wires to a power source that

can be turned on and off with the ignition key. If you

connect the ignition wire to a power source with a

constant voltage supply, such as with battery wires,

the battery may be drained.

• If the fuse blows, first make sure the wires are not

touching to cause a short circuit, then replace the old

fuse with one with the same rating.

• Insulate unconnected wires with vinyl tape or other

similar material. To prevent a short circuit, do not

remove the caps and do not let the cable out at the

ends of the unconnected wires or the terminals.

• Secure the wires with cable clamps and wrap vinyl

tape around the wires that comes into contact with

metal parts to protect the wires and to prevent short

circuit.

• Connect the speaker wires correctly to the terminals

to which they correspond. The unit may be damaged

or fail to work if you share the

· wires or ground

them to any metal part in the car.

• When only two speakers are being connected to the

system, connect both connectors either to the front

output terminals or to the rear output terminals (do

not mix front and rear). For example, if you connect

the ª connector of the left speaker to a front output

terminal, do not connect the · connector to a rear

output terminal.

Parts list for installation

Note: This parts list does not include all the package

contents.

¥ Wiring harness (× 1)

ø Extension wire, 2 m (× 1)

π Microphone, 3 m (× 1)

[ Mounting sleeve (× 1)

“ Trim plate (× 1)

] Extraction keys (× 2)

ENGLISH

00_KWV_2019ST_EQ_EN.indb 4100_KWV_2019ST_EQ_EN.indb 41 29/6/2018 11:57:05 AM29/6/2018 11:57:05 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

JVC KW-V255DBT Seite 45

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von JVC KW-V255DBT

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info