CAUTION
•
(If the ventilation openings or holes are blocked
by a newspaper or cloth, etc., the heat may not be
able to get out.)
• fl ame sources, such as
lighted candles, on the apparatus.
•
must be considered and local rules or laws
governing the disposal of these batteries must be
followed strictly.
•
dripping or splashing and that no objects fi lled
with liquids, such as vases, shall be placed on the
apparatus.
•
Dear Customer,
This apparatus is in conformance with the valid
European directives and standards regarding
electromagnetic compatibility and electrical safety.
European representative of Victor Company of
Japan, Limited is:
JVC Technology Centre Europe GmbH
P.O. Box 10 05 52
61145 Friedberg
Germany
PORTABLE AUDIO SYSTEM
RA-P10
LVT1634-004A [B]
©2006 Victor Company of Japan, Limited 0906NSMCREBET
Warnings, Cautions and Others
Caution: Proper Ventilation
To avoid risk of electric shock and fi re, and to prevent damage, locate the apparatus as follows:
Front: No obstructions and open spacing.
Sides/ Top/ Back: No obstructions should be placed in the areas shown by the dimensions below.
Bottom: Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand
with a height of 10 cm
or more.
15cm
15cm
15cm
10cm
Front Side
Getting Started
Warning
•
consult a doctor immediately.
• fi re. Doing any of these things
may cause the battery to give off heat, crack, or start a fi re.
•
crack, or start a fi re.
•
give off heat, crack, or start a fi re.
•
crack, or start a fi re.
•
•
sunshine, fi re or the like.
Operating on the Remote Control
Supplied Accessories
After unpacking, check to be sure
that you have all the following items.
• Remote
• AC
• Attachments
•
•
One is loaded on the remote
control at the factory.
Prepare the Remote
Control
•
control for the fi rst time, pull
out the insulation sheet.
Replacing the Battery
in the Remote Control
•
remote control by matching
the polarity (+ and –)
correctly.
Insulation sheet
Lithium
coin battery
(CR2025)
Preparation of the Unit
9V 1.5A
Loading batteries for the Clock
Be sure to match the poles (+/-) correctly.
Lithium coin
battery
(CR2025)
(supplied)
FM wire antenna
(Pass through the notch in the cover)
AC adaptor: AA-R9030 (supplied)
To a wall outlet
Plug the AC adaptor
only after all connections
are completed.
1
SOURCE
Switch the sound source.
2
FM MODE button
Switch FM stereo/monaural.
3
MUTING
Turn off the sound. Return to original mode by
pressing again.
4
PRESET
Select a registered FM radio station (P01 to 20).
5
iPod 6 button
Play/pause the iPod.
6
button
Switch the backlight on/off.
7
4 /¢ button
Fast-forward/rewind the iPod song.
Change frequencies to tune in to FM radio
station.
8
VOLUME
You can adjust the volume level from 00 to a
maximum of 20.
Troubleshooting
If you are having a problem with your System, check this list for a possible solution before calling for service.
In These Cases Check the following points
Power does not come on. •
•
No longer works. Press the “RESET” button (see “Resetting the unit”).
Cannot set the iPod. • fi rm the
compatibility of iPod and attachments in “iPod Compatibility Chart”.
•
attachment properly.
Cannot operate iPod. • fi rmly connected to the connector plug of the unit?
•
condition.
iPod cannot be charged. • fi rmly connected to the connector plug of the unit?
•
is operated on batteries.
•
(see “Charging the iPod”).
Hard to listen to broadcasts
because of noise.
The FM antenna is not properly extended and positioned.
Unable to operate the System
from the remote control.
•
System is blocked.
•
When the volume level is
manually set higher than “08”,
the unit automatically lowers
the level to “08”.
The unit’s battery runs low (The “---” (Low battery) appears on the display).
Replace the batteries with new ones.
Resetting the unit
If “Troubleshooting” does not eliminate malfunctioning (failure to operate or
display properly, etc.), press the “RESET” button on the rear of the unit with
something having a sharp point, while the unit is turned on. After pressing
“RESET” button, unplug the AC adaptor and wait a while before plugging it
again.
•
•
the unit.
Specifi cations
Model RA-P10
Type Portable audio system
Amplifi er
Power Output 4W x 2
1kHz 10% THD, 6Ω (IEC268-3)
Input Sensitivity/ Impedance AUX Input 250mV/47kΩ
FM Tuner
Tuning Range 87.50MHz - 108.00MHz
Frequency Step 50kHz
Preset Stations 20
Speaker 1way full range, diameter 35mm x2
Input Terminal
External DC IN ( for AC adaptor)
AUX IN (mini jack)
Power Source
DC9V
1.5A (EXTERNAL DC IN)
DC9V
(SIZE R6, AA BATTERY OR EQUIVALENT x6)
DC3V
(CR2025, for the clock)
AC adaptor
Input : AC 110-240V
, 50/60Hz
Output : DC 9V
1.5A
Dimensions (W x H x D) (W) 331 mm x (H) 71 mm x (D) 98 mm
Weight (Without batteries) 0.7kg
Accessory See Supplied Accessories
Specifi cations and appearance are subject to change without prior notice.
1
2
3
4
5
6
7
8
INSTRUCTIONS
EN
Open the battery compartment
cover by pressing the small tab.
Loading batteries for the Unit (The battery power supply)
Close the cover in the order shown by the numbers.
R6 (SUM-3)/AA (15F) (not supplied)
CAUTION:
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Connecting the AC adaptor
Insert three batteries to each compartment (six batteries total). Be sure to match the poles (+/-) correctly.
While the AC adaptor is connected to the wall outlet, the unit works without batteries.
Press the tab to open
the cover.
Close the cover in the order
shown by the numbers.
CAUTION:
To avoid risk of fi re, and to prevent damage.
•
Do not use AC adaptors except for the supplied AC adaptor.
•
(Front side)
(Rear side)
NOTES
•
•
approximately 7 m distance when the remote control is pointed directly. If the
remote control is pointed with an angle, the distance may become shorter.
Precautions
•
•
• Leave fi cient distance between the System and the TV.
•
DO NOT install the System in a location
near heat sources, or in a place subject to
direct sunlight, excessive dust or vibration.
SAFETY INSTRUCTIONS
“SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT”
This equipment has been designed and manufactured to meet international safety standards but, like any
electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured.
Do read the operating instructions before you attempt to use the equipment.
Do ensure that all electrical connections (including the mains plug, extension leads and interconnections
between pieces of equipment) are properly made and in accordance with the manufacturer’s instructions.
Switch off and withdraw the mains plug when making or changing connections.
Do consult your dealer if you are ever in doubt about the installation, operation or safety of your equipment.
Do be careful with glass panels or doors on equipment.
DON’T continue to operate the equipment if you are in any doubt about it working normally, or if it is
damaged in any way—switch off, withdraw the mains plug and consult your dealer.
DON’T remove any fi xed cover as this may expose dangerous voltages.
DON’T leave equipment switched on when it is unattended unless it is specifi cally stated that it is designed
for unattended operation or has a standby mode.
Switch off using the switch on the equipment and make sure that your family know how to do this.
Special arrangements may need to be made for infi rm or handicapped people.
DON’T use equipment such as personal stereos or radios so that you are distracted from the requirements
of traffi c safety. It is illegal to watch television whilst driving.
DON’T listen to headphones at high volume as such use can permanently damage your hearing.
DON’T obstruct the ventilation of the equipment, for example with curtains or soft furnishings.
Overheating will cause damage and shorten the life of the equipment.
DON’T use makeshift stands and NEVER fi x legs with wood screws—to ensure complete safety always fi t
the manufacturer’s approved stand or legs with the fi xings provided according to the instructions.
DON’T allow electrical equipment to be exposed to rain or moisture.
ABOVE ALL
– NEVER let anyone, especially children, push anything into holes, slots or any other opening in the
case —this could result in a fatal electrical shock.;
– NEVER guess or take chances with electrical equipment of any kind—it is better to be safe than sorry!
9V 1.5A
RA-P10-B_EN.indd 1RA-P10-B_EN.indd 1 10/3/2006 11:53:55 AM10/3/2006 11:53:55 AM
