Bedienungsanleitung JVC RD-HA3 (Seite 24 von 32) (Englisch)

57200

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

Reference

Notes on Handling

Suitable Locations for the System

• Install the System in a location with adequate ventilation to

prevent internal heat build-up in the System.

• Install in a place which is level, dry and neither too hot nor

too cold—between 5°C and 35°C.

• Leave sufficient distance between the System and the TV.

Precautions

Power sources

• When unplugging the System from the wall outlet, always

pull on the plug, not the AC power cord.

• If you are not going to operate the System for an extended

period of time, unplug the AC power cord from the wall

outlet.

Internal heat

• Make sure there is good ventilation around the System.

Poor ventilation could cause the System to overheat and

become damaged.

Others

• Should any metallic object or liquid fall into the System,

unplug the AC power cord and consult your dealer before

operating any further.

If anything goes wrong, unplug the AC power cord and

consult your dealer.

Condensation

Moisture may condense on the lenses inside the System in

the following cases:

• After starting to heat the room

• In a damp room

• If the System is brought directly from a cold place into a

warm place.

Should this occur, the System may malfunction. In this case,

leave the System turned on for a few hours until the moisture

evaporates, unplug the AC power cord, then plug it in again.

Maintenance

To get the best performance out of the System, keep your

discs and the mechanism clean.

Cleaning the System

• Stains should be wiped off with a soft cloth. If the System

is heavily stained, wipe it with a cloth soaked in water-

diluted neutral detergent and wrung well, then wipe clean

with a dry cloth.

• Since the System may deteriorate in quality, become

damaged or get its paint peeled off, be careful about the

following:

– DO NOT wipe it with a hard cloth.

– DO NOT wipe it forcefully.

– DO NOT wipe it with thinner or benzine.

– DO NOT apply any volatile substances such as

insecticides to it.

– DO NOT allow any rubber or plastic to remain in contact

for a long time.

Handling discs

• Remove the disc from its case by holding it at the edge

while pressing the center hole lightly.

• Do not touch the shiny surface of the disc, or bend the disc.

• Put the disc back in its case after use to prevent warping.

• Be careful not to scratch the surface of the disc when

placing it back in its case.

• Avoid exposure to direct sunlight, extreme temperature,

and moisture.

To clean the disc:

Wipe the disc with a soft cloth in a straight line from center

to edge.

DO NOT install the System in a location near

heat sources, or in a place subject to direct

sunlight, excessive dust or vibration.

DO NOT handle the AC power cord with wet

hands.

DO NOT block the ventilation openings or

holes. If they are blocked by a newspaper or

cloth, etc., the heat may not be able to get out.

DO NOT disassemble the System since there

are no user serviceable parts inside.

RDHA3[B].book Page 21 Wednesday, June 6, 2007 5:00 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

JVC RD-HA3 Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von JVC RD-HA3

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info