Bedienungsanleitung JVC RD-HA3 (Seite 27 von 32) (Englisch)

57200

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

Reference

• For MP3/WMA/WAV playback...

– This System can play back MP3/WMA/WAV files with

the extension code <.mp3>, <.wma>, or <.wav>

(regardless of the letter case—upper/lower).

– It is recommended that you make each MP3/WMA file at

a sampling rate of 44.1 kHz and at a bit rate of 128 kbps.

For WAV files: 44.1 kHz/16 bit. This System cannot

play back files made at a bit rate of less than 64 kbps.

– This System can play only a disc of ISO 9660 Level 1 or

Level 2.

– This System may not play back some files even though

their formats are listed above.

– This System does not support DRM (Digital Rights

Management).

– MP3/WMA/WAV discs require a longer readout time

than regular CDs. (It depends on the complexity of the

group/file configuration.)

– Some MP3/WMA/WAV files cannot be played back and

will be skipped. This results from their recording

processes and conditions.

Listening to an iPod (see pages 16 and 17)

Playing the iPod:

• Sound distortion may occur when playing back audio

sources with high recording levels. When this occurs, it is

recommended to turn off the equalizer of the iPod, or turn

on the sound check function of the iPod. For information

on operating the iPod, refer to the instructions supplied

with your iPod.

• JVC is not responsible for any loss of or damage to an iPod

that might result from the use of this product.

• When you connect your iPod to the cable, make sure it

connects all the way in.

• Do not carry the System with an iPod connected. You

might drop it down or it might cause damages to the

connectors.

• Do not touch or hit the iPod terminal pins or the connector

pins directly. They might be damaged.

• Remove the iPod from the cable when not in use.

• You cannot send any data to your iPod from the System.

Listening to External Components (see pages 18

and 19)

Switching to LINE Automatically—QP Link:

• When QP Link fails due to a weak sound signal from the

LINE IN jack, Auto Standby may turn the System off even

if you can hear the sound from the speakers.

In such cases, adjust the volume level of the external

component louder so that the System can detect the sound

signal properly.

• Doing one of the following operations will deactivate QP

Link temporarily.

– Changing from LINE to another source.

– Pressing [

(Standby/On)] to turn the System off.

– Turning the System off by the preset Timer.

In such cases, the following will reactivate QP Link:

– When the sound signal from the LINE IN jack stops or is

too weak for about 30 seconds.

– Unplugging the component from the LINE IN jack, then

plugging it in again.

• QP Link may start working when you just plug in the

component to the LINE IN jack or unplug it. This is not a

malfunction.

Timer Operations (see page 20)

Using Daily Timer:

• Daily Timer does not function with iPods that are not

compatible with this System.

• Daily Timer does not function when operating the System

on batteries.

RDHA3[B].book Page 24 Wednesday, June 6, 2007 5:00 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

JVC RD-HA3 Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von JVC RD-HA3

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info