Bedienungsanleitung JVC RX-6000VBK (Seite 29 von 39) (Englisch)

602848

Zoom out

Zoom in

Vorherige Seite

1/39

Nächste Seite

English

COMPU LINK Remote Control System

The COMPU LINK remote control system allows you to operate JVC audio components through the remote sensor on

the receiver.

To use this remote control system, you need to connect JVC audio

components through the COMPU LINK-3 (SYNCHRO) jacks (see

below) in addition to the connections using cables with RCA pin

plugs (see page 5).

• Make sure that the AC power cords of these components are

unplugged before connection. Plug the AC power cords only after

all connections are complete.

Notes:

• If your audio component has two COMPU LINK-3 (SYNCHRO)

jacks, you can use either one. If it has only one COMPU LINK-3

(SYNCHRO) jack, connect it so that it is the last item in the series

of components. (For example, the turntable or CD player in the

diagram above.)

• To operate the cassette deck or MD recorder using the COMPU

LINK remote control system, set the source name correctly. (See

page 11.)

• Refer also to the manuals supplied with your audio components.

This remote control system allows you to use four functions listed

below.

Remote Control through the Remote Sensor on the

Receiver

You can control the connected audio components through the remote

sensor on the receiver using this remote control. Aim the remote

control directly at the remote sensor on the receiver. For details, see

pages 29 and 30.

Automatic Source Selection

When you press the play (

3) button on a connected component or

on its own remote control, the receiver automatically turns on and

changes the source to the component. On the other hand, if you

select a new source on the receiver or on the remote control, the

selected component begins playing immediately.

In both cases, the previously selected source continues playing

without sound for a few seconds.

Turntable

CD player

Cassette deck

MD recorder

COMPU LINK – 3

(SYNCHRO)

Automatic Power On/Off (Standby): only possible

with the COMPU LINK-3 connection

Both the CD player and cassette deck (or MD recorder) turn on and

off (standby) along with the receiver.

When you turn on the receiver, the CD player or cassette deck (or

MD recorder) will turn on automatically, depending on which

component has been previously selected.

When you turn off the receiver, both the CD player and cassette

deck (or MD recorder) will turn off (standby).

Synchronized Recording

Synchronized recording means the cassette deck (or MD recorder)

starts recording as soon as a CD or a record begins playing.

To use synchronized recording, follow these steps:

1. Put a tape in the cassette deck (or an MD in the

MD recorder), and a disc in the CD player (or a

record on the turntable).

2. Press the record (¶) button and the pause (8)

button on the cassette deck (or MD recorder) at

the same time.

This puts the cassette deck (or MD recorder) into recording

pause.

If you do not press the record (¶) button and pause (8) button at

the same time, the synchronized recording feature will not

operate.

3. Press the play (3) button on the CD player or on

the turntable.

The source changes on the receiver, and as soon as play starts,

the cassette deck (or MD recorder) starts recording. When the

play ends, the cassette deck (or MD recorder) enters recording

pause, and stops about 4 seconds later.

Notes:

• During synchronized recording, the selected source cannot be

changed.

• If the power of any component is shut off during synchronized

recording, the COMPU LINK remote control system may not

operate properly. In this case, you must start again from the

beginning.

EN26.RX-6000V[J] 99.12.10, 6:00 PM26

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

JVC RX-6000VBK Seite 29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info