Bedienungsanleitung JVC TH-A10R (Seite 61 von 68) (Englisch)

57099

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

Troubleshooting

Use this chart to help you solvi daily operational problems. If there is anyproblem you cannot solve, conect your JVC service center.

PROBLEM

Power does not come on.

Power is not supplied to the powered

sub-woofer

The remote control does not work.

No sound.

Sound is emitted from only one speaker.

No video.

Cannot play a disc.

Video and audio are distorted.

The edge is missing on the video image.

Continuous static during FM broadcasts.

Unit does not work correctly.

POSSIBLE CAUSE

The power cord.

The power cord has been pulled out of the

AC outlet.

The system cable is not connected.

It is too far from the center unit, or is not

facing the center unit.

There is something obstructing the remote

sensor.

The battery is flat.

The battery has been inserted the wrong way

round (+/–).

Sunlight is falling directly on the detector.

The entered manufacturers code number is

incorrect.

The system cable is not connected.

The speaker cord is not connected.

There is a short in the speaker cord.

The powered sub-woofer power supply is off.

The audio cord is not connected properly.

An incorrect source has been selected.

Muteing is on.

The speaker cord is not connected correctly.

Left-right balance is incorrect.

The video cord is not connected properly.

TV input select is incorrect.

A non-NTSC disk has been inserted.

The unit and disk region numbers (local

numbers) are incompatible.

The disc is dirty.

A video deck is connected between the

center unit and the TV.

Initial setup (monitor type) was incorrect.

The TV has been set up incorrectly.

The received signal is too weak.

The station is too far away.

The antenna is not connected correctly.

Lightning and electronic noise interferes

with operation of the microcomputer.

Immediately after beginning to heat the

room, the unit was moved to a cold location

causing condensation to form inside.

SOLUTION

Insert the plug into the socket.

Press the power button on the center unit to

switch power OFF, and then press it again to

switch power ON.

Avoid any obstacles within approximately 5 m

of the detector on the remote control.

Replace the battery.

Insert the battery correctly.

Shade the remote control from direct sunlight.

Enter the correct code number.

Check the connection.

Reconnect the speaker cord and press POWER

on the center unit to restart the system.

Insert the plug firmly into the socket and press

POWER on the center unit to switch power off,

and then press it again to switch power on.

Connect the cord properly.

Select the correct source.

Press MUTING to clear mute.

Connect the cord properly.

Adjust balance.

Connect the cord properly.

Select the correct input.

Replace the disc.

Clean the disc.

Connect the center unit and TV directly.

Run through initial setup again correctly.

Set up the TV correctly.

Connect an external FM antenna, or contact

your dealer.

Select another station.

Check the connection.

Switch power off, and remove and re-insert the

power plug in the socket.

Switch power off and leave the unit a few

hours before switching power on again.

TH-A10[J]7/1 00.2.24, 14:5959

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

JVC TH-A10R Seite 61

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von JVC TH-A10R

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info