Bedienungsanleitung JVC UXH30 (Seite 14 von 32) (Englisch)

29938

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

Adjusting the Tone (Bass/Treble)

You can adjust the bass level (low frequency range)

and the treble level (high frequency range) within a

range of –5 to +5.

When shipped, the bass level set to “BASS 0” and the

treble level set to “TREBLE +1.”

• This function only affects the playback sound, and

does not affect your recording.

• There is a time limit in doing the following steps. If

the setting is canceled before you finish, start over

from step

On the remote control ONLY:

Press BASS to adjust the bass level or

press TREBLE to adjust the treble

level.

Press UP to increase the

level or press

DOWN to

decrease it.

Reinforcing the Bass Sound

You can reinforce the bass sound to maintain rich, full

bass at low volume—Active Hyper Bass Pro.

• This function only affects the playback sound, and

does not affect your recording.

To get the effect, press AHB PRO so

that the

BASS

indicator lights up on the

display.

• Each time you press the button, the

bass reinforcement alternates between on (AHB ON)

and off (AHB OFF).

To cancel the effect, press AHB PRO again so that the

BASS

indicator goes off.

Turning On the Power

To turn on the unit, press

STANDBY/ON

( on the unit).

The STANDBY lamp on the unit goes off.

• When you press the source button

—3/8 CD, 2 3 TAPE, TUNER (or

BAND TUNER on the unit) and AUX, the unit

automatically turns on and starts playback if the

source is ready.

To turn off the unit (standby), press

STANDBY/ON ( on the unit) again.

The STANDBY lamp on the unit lights on.

• The CLOCK indicator and “0:00” flash on the

display until you set the built-in clock. After setting

the clock, the clock time will appear on the display

while the unit is on standby.

• A little power is always consumed even while the

unit is on standby.

To switch off the power supply completely, unplug

the power cord.

When you unplug the power cord or if a power

failure occurs

The clock is reset to “0:00” right away, while the tuner preset

stations (see page 12) will be erased in a few days.

Adjusting the Volume

You can adjust the volume level only while the unit is

turned on. The volume level can be adjusted between

“VOL MIN” and “VOLUME 1” – “VOLUME 40

(VOL MAX).”

Press VOLUME + to increase the

volume or press VOLUME – to

decrease it.

For private listening

Connect headphones to the PHONES jack. No sound comes

out of the speakers. Be sure to turn down the volume before

connecting or putting on headphones.

DO NOT turn the unit off (standby) with the

volume set to an extremely high level;

otherwise, the sudden blast of sound can

damage your hearing, speakers and/or

headphones when you turn on the unit or

start playing any source next time.

REMEMBER you cannot adjust the volume

level while the unit is on standby.

VOLUME

BASS

TREBLE

DOWN

AHB PROAHB PRO

STANDBY/ON

EN01-15_UX-H30[B]f.pm6 02.12.26, 1:36 PM11

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

JVC UXH30 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info