56705
20
Zoom out
Zoom in
Vorherige Seite
1/32
Nächste Seite
17
Using the Tuner
To Change the FM Reception
Mode
(Using the Remote Control)
When you are tuned into an FM stereo broadcast, the
STEREO indicator lights up and you can hear stereo ef-
fects.
If an FM stereo broadcast is hard to receive or noisy, you
can select Monaural mode. Reception improves, but you
lose stereo effect.
Press the FM MODE button on the Remote Control
so that the MONO indicator lights up on the dis-
play.
To restore the stereo effect,
press the FM MODE button
on the Remote Control so that the MONO indicator goes off.
Receiving FM Stations with RDS
(Using the Remote Control)
You can use the RDS (Radio Data System) by using the Re-
mote Control.
RDS allows FM stations to send additional signals with
their regular programme signals. For example, the stations
send their station names, and information about what type
of programmes they broadcast, such as sports or music, etc.
This unit can receive the following types of RDS signals:
PS (Programme Service):
shows commonly known station names.
PTY (Programme Type):
shows types of broadcast programmes.
RT (Radio Text):
shows text messages the station sends.
What information can RDS signals provide?
The display shows RDS signal information that the station sends.
To show the RDS signals on the display
Press the DISPLAY MODE button while listening
to an FM station.
Each time you press the button, the display changes to show
information in the following order:
PS (Programme Service):
While searching, WAIT PS appears, then station name is
displayed. NO PS appears if no signal is sent.
PTY (Programme Type):
While searching, WAIT PTY appears, then broadcast
programme type is displayed. NO PTY appears if no sig-
nal is sent.
RT (Radio Text):
While searching, WAIT RT appears, then a text message
sent by the station is displayed. NO RT appears if no signal
is sent.
Station Frequency:
Station frequency (non-RDS service)
If searching finishes at once, “WAIT PS”, “WAIT PTY” and
“WAIT RT” will not appear on the display.
If you press the DISPLAY MODE button while listening to
an AM (MW/LW) station, the display only shows station
frequency.
RDS is not available for AM (MW/LW) broadcasts.
MONO
FM MODE
PS PTY RT Frequency
DISPLAY
MODE
VS-DT6-9R(B)_EN.book Page 17 Thursday, January 17, 2002 1:26 PM
20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für JVC VS-DT9 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von JVC VS-DT9

JVC VS-DT9 Bedienungsanleitung - Deutsch, Holländisch, Französisch - 94 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info