Bedienungsanleitung JVC WR-MG100 (Seite 2 von 103) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

452892

Zoom out

Zoom in

Vorherige Seite

1/103

Nächste Seite

In order to use this product safely

Preparation (A Pg. 6)

• Check that there is no dirt, cracks, or damage to

the O-ring.

• Always apply grease to the O-ring.

Attaching the Marine Case to the Camera

(A Pg. 7, 8)

• Make sure that the O-ring is not twisted, and that

you do not forget to attach it.

• When tightening the seal, make sure there are

no foreign objects caught in the seal.

Recording the Video/Still Image Files

(A Pg. 8, 9)

• Avoid opening and closing the marine case in

the shooting location.

• When holding the marine case, lower it gently

into the water.

Detaching the Marine Case/Maintenance

(A Pg. 9, 10, 11)

• Always wash the marine case in fresh water

after use.

• Perform maintenance on the O-ring.

If water leaks into the case due to careless use of

the marine case, JVC cannot accept responsibility

for any damage that may occur to the internal

equipment and materials (video camera, SD card,

etc.), or any expenses incurred in taking the

photographs/video. Therefore, please be careful

when using the marine case.

Before use, this unit must be pre-

tested to check if there is any water

leakage.

This marine case is a precision instrument

designed to permit safe video recording under

high water pressure. Please pay careful attention

when handling the unit before and after use, as

explained in this user’s manual.

Each part of the marine case has been subject to

strict controls during the manufacturing process,

and the individual functions have faced stringent

tests during the assembly process. Each marine

case has also had to pass waterproof inspections

using high-pressure water testers. However,

damage can sometimes occur during transport

and distribution, or during storage after purchase,

so before diving always carry out the following

pre-use test to verify safety.

Pre-use test

Be sure to perform the following pre-use test

before diving.

1. Before mounting the camera inside the

marine case, dive with only the empty

marine case and test for water leaks.

Allow 5 or 6 minutes to ensure there are no

leaks.

Be sure to perform this test to ensure the

safety of your camera.

2. The following are some common causes of

water leaks:

Safety Precaution

Please read before use

A. The marine case is used without attaching

the O-ring.

B. The O-ring is not mounted in the correct

position.

C. The O-ring is damaged or deformed.

D. There is sand, dirt, hair or other foreign

matter on the O-ring.

E. There is sand, dirt, hair or other foreign

matter on the contact surface of the O-ring

or on the inside of the lid.

F. The provided strap or drying agent bag is

pinched inside the marine case when the lid

is closed.

WR-MG100_EN.book Page 2 Wednesday, December 5, 2007 1:23 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

JVC WR-MG100 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info