Bedienungsanleitung JVC WR-MG200 (Seite 10 von 104) (Deutsch, Englisch, Holländisch, Französisch, Italienisch)

57406

Zoom out

Zoom in

Vorherige Seite

1/104

Nächste Seite

Always perform maintenance on the marine case

after you have finished recording.

Salt crystal or dirt will accumulate inside the

marine case if maintenance is not performed, and

this can cause water leakage.

z Do this within 30 minutes after diving.

z Pour in fresh water until the marine case is

completely submerged in the container, and

shake the marine case in the upward,

downward, left and right directions.

z Move the buttons and levers while the marine

case is submerged, and rinse the dirt out from

any gaps or grooves. Proceed to C

z If used in the sea

-> Proceed to

Aerforming salt removal

If the marine case was used in the sea, submerge

the marine case in fresh water for at least 1 hour

to remove salt.

Prepare a container that contains fresh

water that is five times more than the

volume of the marine case.

z The container must be big enough to allow

the marine case to submerge fully.

z If only small containers are available, pour

in fresh water that is equivalent to at least

five times the volume of the marine case

over a few times.

z Shaking the marine case in the upward,

downward, left and right directions will be

more effective.

z Move the buttons and levers while the

marine case is submerged, and rinse the

salt out from any gaps or grooves etc.

z Make sure the grip is also free of salt.

Put in fresh water for at least 1 hour.

Remove the marine case and wipe off

water droplets on the case surface using a

dry towel.

Remove the camera.

z Face the front glass of the marine case

upwards, and open the buckles to remove

the camera, while paying attention not to let

water droplets at O-ring or buckles enter

the case.

z The camera may fall out if the buckles are

opened with the front glass facing down.

z If you cannot avoid opening the marine case at

the diving location, pay attention not to let

water droplets from your hair or your body

enter the case.

Remove the O-ring, and wipe off salt, sand

and other foreign matter.

z Also wipe the groove in which the O-ring

was inserted, and the part of the marine

case that was in contact with the O-ring,

and allow them to dry.

¹ For details on handling and storing the

O-ring, refer to the “O-ring Maintenance

Manual”.

Wipe the inside and outside of the marine

case with a dry cloth.

¹ Use a lint-free cloth to wipe the inside of

the marine case.

Wipe the inner side of the front glass.

z Add a few drops of the cleaner liquid onto

the inner side of the front glass, and wipe

off using lens tissue paper etc.

z The front glass will fog if it is dirty.

Maintenance on the marine case

Wash the marine case in water

while it is still sealed

Performing salt removal

Caution

Dirt, sand, salt

crystals, etc.

Hair, lint, etc.

WR-MG200_EN.book Page 10 Friday, May 23, 2008 9:15 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

JVC WR-MG200 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info