Bedienungsanleitung Kalorik CM 25282 - K111026 (Seite 5 von 24) (Englisch, Französisch, Spanisch)

612218

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite



Copies of the I/B. Please reproduce them without any

changes except under special instruction from Team

International BELGIUM. The pages must be reproduced and

folded in order to obtain a booklet A5 (+/- 148.5 mm width x

210 mm height). When folding, make sure you keep the good

numbering when you turn the pages of the I/B. Don’t change

the page numbering. Keep the language integrity. Print only

what is inside the frame.

5 USK CM 25282 - 111026

Assembly page 5/24

Fax +32 2 359 95 50

PREPARATION OF COFFEE

• Open the lid of the water tank and pour the desired volume of water in

it. The water level can be read off the water level indicator. Never

exceed the maximum level indicated.

• Insert filter paper in the filter holder and add the desired quantity of

ground coffee using the provided scoop.

• Never forget to close the water tank lid before switching on the coffee

maker.

• Put the jug with closed lid on the hotplate.

• Plug in the coffee maker. Press the ON/OFF button once. The red RUN

light, will be illuminated, indicating that your appliance is in use. Thanks

to the keep warm function, your coffee stays warm as long as the

appliance is switched on (for 2 hours, unless coffee maker gets switched

off by user)

• Your coffee maker is equipped with a “Pause-and-Serve” function,

which means that when you remove the jug from the appliance, a non-

drip valve will automatically operate to stop any drops of coffee falling

onto the hotplate. When you put the jug back into place, the non-drip

valve opens automatically and allows remaining coffee to filter through

into the jug.

• Wait until the brewing process is finished and the filter is empty before

removing the jug.

• Practical hints: When the water tank is empty, wait a few more minutes,

as some water might still drip out of the filter before removing the jug.

• Note: a 2-hour auto-shut off feature is activated when operating the

coffee maker manually

PROGRAMMING THE COFFEE MAKER

• To program your coffee maker to brew fresh coffee at a preset time, first

follow steps 1 to 4 in the “PREPARATION OF COFFEE” section.

• Make sure the coffee maker’s clock is set to the right time.

• Press the PROG button twice. The clock will now display 12:00 with the

word “TIMER” in the upper left corner. Use the HOUR and MINUTE buttons

to set the desired brew time. Press PROG to validate the timer setting.

• Press the START/STOP button twice to activate the preset brew cycle.

The green AUTO light will illuminate when the brew time is properly set.

• When your preset brew time is reached and the coffee maker starts its

brew cycle, the green AUTO light will go out and the red ON light will

illuminate.

• As with the regular brew cycle, an automatic two hour keep warm

cycle will commence after your coffee maker has finished brewing. At

the end of the two hours, the coffee maker will automatically shut itself

off.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kalorik CM 25282 - K111026 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info