Bedienungsanleitung Kalorik KA CH 3 (Seite 6 von 16) (Englisch, Portugiesisch, Spanisch)

491056

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite



Copies of the I/B. Please reproduce them without any

changes except under special instruction from Team

International BELGIUM. The pages must be reproduced and

folded in order to obtain a booklet A5 (+/- 148.5 mm width x

210 mm height). When folding, make sure you keep the good

numbering when you turn the pages of the I/B. Don’t change

the page numbering. Keep the language integrity.

6 KA CH 3 - 060622

Assembly page 6/16

Fax +32 2 359 95 50

CLEANING AND MAINTENANCE

Warning: The unit must be unplugged from the power supply prior to any maintenance or

cleaning in order to reduce the risk electric shock or fire.

A. Light bulb replacement procedure

Most light bulbs are rated to last approximately 3000 hours. Like all light bulbs, bulbs require

periodic replacement. When the bulbs in your unit have burned out you will notice one or

more of the following:

 Contrasting light is dark

 The flame is dim or dark in certain areas

 The log set ember bed appears dim or dark in certain areas

Your unit must be opened in order to replace the light bulbs. To reduce the number of times

you need to open the unit, replace all the lights bulbs at the same time if they are close to the

end of their rated life.

Warnings:

 The light bulbs in your unit can become extremely hot. Allow at least 10 minutes between

turning off the unit and removing the light bulbs to avoid the accidental burning of the

skin.

 Always make sure to replace the bulbs by a bulb with exactly the same features.

Replacing the flame generation bulbs: first open the side panels by simply pulling at them (fig.

2) Unscrew the four screws that are fixing the top panel (2 at each side) (fig. 3) and remove the

top panel. Locate the flame generation cylindrical drum (fig. 4), remove the round pieces of

the drum cylinder by slightly squeezing the cover of the cylinder (fig. 5). You will see two light

bulbs, pull out the old ones and replace them by new ones. After having replaced the bulbs,

make sure to reassemble the cylinder correctly. Close reattach the top panel and close the

side panels.

Replacing the top contrasting light bulbs and the log set ember bed light bulbs: first remove the

front glass door by releasing the screws situated at the right and left side of the glass door (fig.

6). You now have access to the top bulbs (fig. 7) in order to replace them. Pull forward and lift

up the log set ember bed to remove it (fig. 8). Replace the light bulb of the log set ember bed

(fig.9). Once this is done, put the log set ember bed back in its initial position and close the

glass door.

B. General cleaning instructions

 The housing may be wiped with a slightly damp, lint-fee cloth; do not use any abrasive

scouring pad or steel wool.

 Do not use detergents or cleaning products.

 If necessary, dust particles accumulated in the air outlet openings may be removed with a

vacuum cleaner.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kalorik KA CH 3 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info