Bedienungsanleitung Kalorik TKG HL 14 N (Seite 6 von 32) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch)

487701

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite



Copies of the I/B. Please reproduce them without any

changes except under special instruction from Team

International BELGIUM. The pages must be reproduced

and folded in order to obtain a booklet A5 (+/- 148.5 mm

width x 210 mm height). When folding, make sure you

keep the good numbering when you turn the pages of

the I/B. Don’t change the page numbering. Keep the

language integrity.

6 TKG HL 14 N - 100519

Assembly page 6/32

Fax +32 2 359 95 50

POSITIONING OF THE APPLIANCE

The heater should only be operated at a minimum distance of 50cm from any wall or other

object. Position the air flow in order to optimise the heating of the room. Avoid corners, small

volumes, floors and ceilings.

OPERATION

When the appliance is switched on for the first time, a slight smell may be emitted. Please

ensure sufficient ventilation. This smell will disappear very quickly.

1. Plug in the appliance.

2. Adjust the direction of the airflow with the frontal grid.

3. Turn the selector to the desired position.

0 OFF

Fan without heater

~ Low heat output (1000W)

≈ Full heat output (2000W)

The pilot light will illuminate to indicate that the appliance is in use.

4. If you selected low or full heat output, choose the desired temperature with the

thermostat. With the thermostat, the temperature can be regulated steplessly. When the

desired temperature is reached, the unit will automatically switch off. Once the

temperature has fallen below the pre-set level, the heater will switch on again.

5. To switch off the appliance, put the selector in position "0".

Frost protection: If the thermostat is set to its “*” position with the selector in ~ or ≈ position, the

unit will switch on once the temperature has fallen below +5°C. Make sure the heat output is

sufficient to keep the room temperature above freezing point.

OVERHEATING PROTECTION

This heater is protected with an overheating protection that switches off the appliance

automatically in case of overheating, e.g. due to the total or partial obstruction of the grids. In

this case, unplug the appliance, wait about 10 minutes for it to cool and remove the object

that is obstructing the grids. Then switch it back on as described above. The appliance should

operate normally. Should the problem persist, please contact the nearest customer service.

CLEANING AND CARE

 Before cleaning the appliance, ensure it is disconnected from the power supply and has

cooled down completely.

 To avoid the risk of electric shock, do not clean the heater with water and do not immerse

it in water or any other liquid.

 The housing may be wiped with a slightly damp, lint-free cloth.

 If necessary, dust particles accumulated in the air outlet openings may be removed with a

vacuum cleaner.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kalorik TKG HL 14 N Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info